This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
handover:r1766 [2016/11/14 17:09] Lucas Hyland |
handover:r1766 [2016/11/15 00:46] Jamie McCallum |
||
---|---|---|---|
Line 15: | Line 15: | ||
Disk vsn: BKG+0142/4000 | Disk vsn: BKG+0142/4000 | ||
- | Start position: 0.000 GBs | + | Start position: 3.269 GBs |
- | * Autocorrelation spectrum at Hobart is a mess. Reconfigured dbbc and still no change. I'll see what happens after the experiment begins and if it fixes itself (Lucas). | + | * Autocorrelation spectrum at Hobart is a mess. Reconfigured dbbc and still no change. I'll see what happens after the experiment begins and if it fixes itself (Lucas). Update: after first scan it was fine. Must have been the bug in the plotting program. |
+ | * Experiment started ok (Lucas). | ||
+ | * 0042 - Ran fmset to correct jumps in reported pps_delay through the DBBC. (JMc) | ||
**Katherine** | **Katherine** | ||
Disk vsn: HOB+0094/160000 | Disk vsn: HOB+0094/160000 | ||
- | Start position: 9049.846 GBs | + | Start position: 9051.643 GBs |
* Getting error 'computer to acu time difference exceeded 0.25 seconds, see value above' every second. All the delays are fine and the beep is extremely annoying. Wiki says error is meaningless (probably network issues?) but I cannot turn the beep off (Lucas). | * Getting error 'computer to acu time difference exceeded 0.25 seconds, see value above' every second. All the delays are fine and the beep is extremely annoying. Wiki says error is meaningless (probably network issues?) but I cannot turn the beep off (Lucas). | ||
+ | * Experiment started ok (Lucas). | ||
+ | * 2200 - Rebooted drives in HMI to clear the ACU time difference problem. (JMc) | ||
Line 30: | Line 34: | ||
Disk vsn: HOB0104/16000 | Disk vsn: HOB0104/16000 | ||
- | Start position: 7875.337 GBs | + | Start position: 7877.132 GBs |
+ | |||
+ | * Experiment started ok (Lucas). | ||