This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

--- operations:documentation.dbbcsetupivs [2014/03/24 23:52]
Vasaant Krishnan
+++ operations:documentation.dbbcsetupivs [2014/10/21 17:32]
liza
@@ Line 52: / Line 52: @@
 </code>
-The target values for the total power readings is 56000. this can be checked by the command: ifa, ifb, ifc or ifd. If the levels are too high or low, then adjust the attenuation on the IF box. Note that the levels on IF C (ifc) are a bit low. Don't worry about it.
+Recommended DBBC power levels can be found [[hardware:dbbc.targetifpower|here]]. Current target values for the total power readings is 56000. this can be checked by the command: ifa, ifb, ifc or ifd. If the levels are too high or low, then adjust the attenuation on the IF box. Note that the levels on IF C (e-remote control command: ifc) are a bit low. Don't worry about it.