This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
operations:documentation.ivs [2012/05/25 01:07] Jamie McCallum [Setting Up] |
operations:documentation.ivs [2013/05/08 00:05] Warren Hankey |
||
---|---|---|---|
Line 48: | Line 48: | ||
* disk_pos should report three values - the current number of btyes recorded, bytes at start of previous scan and bytes at start of current scan. If not currently recording, the first and third values should agree.\\ | * disk_pos should report three values - the current number of btyes recorded, bytes at start of previous scan and bytes at start of current scan. If not currently recording, the first and third values should agree.\\ | ||
* decoder time - Check time offset in the formatter with "mk5=dot?" and check that it reports a small offset as the final value, than syncerr_eq_0 and that FHG_on or FHG_off depending on whether it is currently recording or not.\\ | * decoder time - Check time offset in the formatter with "mk5=dot?" and check that it reports a small offset as the final value, than syncerr_eq_0 and that FHG_on or FHG_off depending on whether it is currently recording or not.\\ | ||
- | * Check mode with "mk5=mode?". The result should be "/mk5/!mode? 0 : ext : 0x55555555 : 2 : 2 ;" | + | * Check mode with "mk5=mode?". The result should be "/mk5/!mode? 0 : ext : 0x55555555 : 2 : 2 ; (where the last number is either 1 or 2, the number of disk modules loaded" |