User Tools
operations:documentation.ivs.mark5_module_selection
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
operations:documentation.ivs.mark5_module_selection [2016/08/31 03:58] Warren Hankey |
operations:documentation.ivs.mark5_module_selection [2016/08/31 04:06] Warren Hankey [So which module should I use?] |
||
|---|---|---|---|
| Line 43: | Line 43: | ||
| All R4, CRDS and CRF experiments from Katherine and Yarragadee need to be directly shipped to Washington, so please avoid putting them on a module with another experiment. | All R4, CRDS and CRF experiments from Katherine and Yarragadee need to be directly shipped to Washington, so please avoid putting them on a module with another experiment. | ||
| - | Everything else needs to be shipped to Hobart for e-transfer to the correlator. Therefore, two experiments, if they fit, can go on the same module. However, **R1's** do need to get to Hobart **__ASAP__**. Often there will be an R1 straight after another experiment. It is undesirable, but in a pinch they can go on the same module, providing the R1 is the LAST experiment to be recorded to it (and there is enough disk space!). | + | Everything else needs to be shipped to Hobart for e-transfer to the correlator. Therefore, two experiments, if they fit, can go on the same module. However, **R1's** do need to get to Hobart **__ASAP__**. Often there will be an R1 straight after another experiment. It is undesirable, but in a pinch the R1 can go on the same module with the last experiment, providing the R1 is the LAST experiment to be recorded (and there is enough disk space!). |
| - | So for example, if there has been an Austral and there is still 3TB left on the module, and the R1 will use 2.5TB, put them on the same module. | + | For example; there has been an Austral and there is still 3TB left on the module; there is no separate blank module to put the following R1 on; it is the middle of the night and there is no one at the observatory to load a blank module; the R1 will only use 2.5TB; then you can put the R1 on the same module after the Austral. |
/home/www/auscope/opswiki/data/pages/operations/documentation.ivs.mark5_module_selection.txt · Last modified: 2019/01/25 00:24 by Warren Hankey
Page Tools
