User Tools
operations:documentation.test_tsys
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Last revision Both sides next revision | |||
|
operations:documentation.test_tsys [2012/08/15 04:47] Jim Lovell created |
operations:documentation.test_tsys [2013/09/16 23:49] David Horsley |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| Tsys values are reported after about 15 seconds. Expected values are given in the checklist. If they are unusually high, there could be water (condensation) on the feed window or overcast conditions can raise the Tsys. If you suspect a wet feed window, try another Tsys measurement with the antenna tipped to say 20 degrees elevation (but only after the Antenna checks have been made). | Tsys values are reported after about 15 seconds. Expected values are given in the checklist. If they are unusually high, there could be water (condensation) on the feed window or overcast conditions can raise the Tsys. If you suspect a wet feed window, try another Tsys measurement with the antenna tipped to say 20 degrees elevation (but only after the Antenna checks have been made). | ||
| + | |||
| + | Tsys measurements can be found in the ''SysMon'' group in the e-RemoteCtrl window; however, these are currently formatted strangely. To view the correct output, open an ssh connection to the fs computer and run ''monit3''. | ||
/home/www/auscope/opswiki/data/pages/operations/documentation.test_tsys.txt · Last modified: 2013/09/25 06:18 by Jim Lovell
Page Tools
