This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
operations:temphumidmonitor [2018/09/11 07:13] Jim Lovell [Hardware setup] |
operations:temphumidmonitor [2018/09/11 07:16] Jim Lovell [IR transmitters, receivers] |
||
---|---|---|---|
Line 36: | Line 36: | ||
</code> | </code> | ||
Connect them to the Raspberry Pi. Any GND or +5V pin will be fine. | Connect them to the Raspberry Pi. Any GND or +5V pin will be fine. | ||
- | Use any digital pin on the Pi and make sure they are set to "False" in ''TempHumid.conf'' (you can give them an appropriate label though). | + | Use any digital pin on the Pi and make sure they are set to "False" in ''TempHumid.conf'' (you can give them an appropriate label though). See below. |
==== Accelerometer ==== | ==== Accelerometer ==== | ||
Line 50: | Line 50: | ||
</code> | </code> | ||
+ | Attach the accelerometer to the maser (or whatever you want to measure). You might want to align it according to the orientation diagram on the module. | ||
==== Analog (Eric) Temperature/Humidity Sensor ==== | ==== Analog (Eric) Temperature/Humidity Sensor ==== | ||
This should also be connected to the Arduino: | This should also be connected to the Arduino: |