This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
operations:temphumidmonitor [2018/09/11 07:16] Jim Lovell [Accelerometer] |
operations:temphumidmonitor [2018/09/11 07:24] Jim Lovell |
||
---|---|---|---|
Line 36: | Line 36: | ||
</code> | </code> | ||
Connect them to the Raspberry Pi. Any GND or +5V pin will be fine. | Connect them to the Raspberry Pi. Any GND or +5V pin will be fine. | ||
- | Use any digital pin on the Pi and make sure they are set to "False" in ''TempHumid.conf'' (you can give them an appropriate label though). | + | Use any digital pin on the Pi and make sure they are set to "False" in ''TempHumid.conf'' (you can give them an appropriate label though). See below. |
==== Accelerometer ==== | ==== Accelerometer ==== | ||
Line 63: | Line 63: | ||
- | ===== Software ===== | + | ===== DHT11 monitoring Software ===== |
Software, config file etc are stored in ''~pi/TempHumid'' | Software, config file etc are stored in ''~pi/TempHumid'' | ||
Line 88: | Line 88: | ||
* ''start_THRecord.sh'' and ''start_THServer.sh'' are started automatically after the RPi boots into a desktop session, so a reboot of the RPi should start these processes. They are called from ''~/.config/lxsession/LXDE-pi/autostart''. Edit this file if you want to change what happens when the desktop starts. | * ''start_THRecord.sh'' and ''start_THServer.sh'' are started automatically after the RPi boots into a desktop session, so a reboot of the RPi should start these processes. They are called from ''~/.config/lxsession/LXDE-pi/autostart''. Edit this file if you want to change what happens when the desktop starts. | ||
- | ==== Network config ==== | + | ===== Accelerometer, Analog temp/humid monitoring Software ====== |
+ | A work in progress... | ||
+ | |||
+ | ===== Software for IR remote control of aircon ====== | ||
+ | A work in progress... | ||
+ | |||
+ | ====== Network config ===== | ||
+ | This should be done already, but just in case... | ||
For masertempke the IP address should be 131.217.61.28. | For masertempke the IP address should be 131.217.61.28. | ||
For antennatempke the IP address should be 131.217.61.29. | For antennatempke the IP address should be 131.217.61.29. | ||
Line 109: | Line 117: | ||
[[operations:temphumidmonitorrpi|Configuring Raspberry Pis for Temperature and Humidity monitoring]] | [[operations:temphumidmonitorrpi|Configuring Raspberry Pis for Temperature and Humidity monitoring]] | ||
- | |||