This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
handover:r4774 [2017/01/12 20:35] Nick Ham |
handover:r4774 [2017/01/13 15:28] (current) Warren Hankey |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| * 18:32UT Experiment started late, first scan 012-1832 (Nick) | * 18:32UT Experiment started late, first scan 012-1832 (Nick) | ||
| * 18:32UT Quite a few of the values on the system monitor are red, with drive status and drive control unknown (Nick) | * 18:32UT Quite a few of the values on the system monitor are red, with drive status and drive control unknown (Nick) | ||
| - | * 18:45UT clkoff-maserdelay delay was excessively large (533072.774 us), reconfiguring the DBBC worked as explained at http://auscope.phys.utas.edu.au/opswiki/doku.php?id=operations:monitoring_hb#clkoff_reading_is_drifting_or_far_from_the_maser-gps_offset | + | * 18:45UT clkoff-maserdelay delay was excessively large (533072.774 us), reconfiguring the DBBC worked as explained at http://auscope.phys.utas.edu.au/opswiki/doku.php?id=operations:monitoring_hb#clkoff_reading_is_drifting_or_far_from_the_maser-gps_offset (Nick) |
| + | * Some wind stows. Check logs to note off source times. (Jim) | ||
| + | * 2017.013.06:14:55 ALARM: Large difference between formatter and maser delays. Check for stability of new offset. Reconfigured dbbc. This seemed to work. Hobart was wind-stowed anyway (Lucas) | ||
| + | * 10:30 UT Hobart recovered from 'wind stow'. | ||
| + | * Antenna probably hadn't been wind stowed actually for a while. I noticed the wind speed had dropped to 7.5km/h bu the antenna hadn't recovered. | ||
| + | * Anyway after a few resets of antenna, drives, reboots, system and no change I thought the monica data was wrong since the wind speed didn't change from 7.5km/h. This has worked for me in the past to I tried it first. | ||
| + | * Antenna started setting off alarms due to missed scans and started trying to record data whilst stowed. Never a good sign. Solution was to: | ||
| + | * halt | ||
| + | * disk-record=off | ||
| + | * antenna=off | ||
| + | * terminate fs | ||
| + | * restart | ||
| + | * antenna=open | ||
| + | * antenna=operate | ||
| + | * proc=r4774hb | ||
| + | * schedule=r4774 | ||
| + | And it was away! | ||
| + | * First good scan after recovery 013-1039. | ||
| + | * **IMPORTANT NOTE** I skimmed the logs to see where it went wrong and I think the moment it buggered up was a note that said 'auto-stow recovery failed'. From then on it got stuck in a loop of trying to stow but never getting there. Maybe this should be an alarm?? | ||
| + | * 14:30 Automatic wind stow. Released on it's own. 013-1451 first scan after release. | ||
| + | * 15:20 I think monica weather server isn't working, wind data hasn't updated for a while. I needed to go up to the telescope (to put in a mv004 module) and the wind was very clearly >7.7km/h (it nearly blew me over) that the monitor system showed (Lucas) | ||
| + | * 15:30 Auto-stow released, source 1144-379, but probably not for long (Lucas) | ||
| **Katherine** | **Katherine** | ||
| - | Module HOB+0130/Start 0.00 GB | + | Module NRAO-005 (960 GB)/Start at scan 013-0349 (711.5 GB offset) 711.50 GB |
| - | * 18:32UT Experiment started late, first scan 012-1832 (Nick) | + | * 18:32UT Not running until maser has been fixed. |
| + | * 03:49UT Maser repaired, looks good. Data should be OK from scan 013-0349 onward (Jim) | ||
| Line 22: | Line 44: | ||
| * 18:32UT Experiment started late, first scan 012-1832 (Nick) | * 18:32UT Experiment started late, first scan 012-1832 (Nick) | ||
| - | * 20:35UT onsource command is suggesting the antenna is outside the 'nominal tracking tolerance of 0.0045 degrees, current tolerance 0.0100' (Nick). | + | * 21:50UT Data is invalid prior to scan 012-2151c (was unable to communicate with the DBBC) (Nick) |
| ~~DISCUSSION~~ | ~~DISCUSSION~~ | ||