This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

--- operations:agenda2020_09_24 [2020/09/24 02:04]
Earl Lester created
+++ operations:agenda2020_09_24 [2020/10/08 02:22] (current)
Jayender Kumar
@@ Line 1: / Line 1: @@
-[[operations:agenda2020_09_10|agenda]]
+**Chair:** Jay
+**Next meeting chair:** Eloise
+**Attended:** Mas, Katie, Eloise, Earl, Prad, Jamie, Patrick, Lim
+**Apologies:**  Simin, Tiege,
+**General Issues**
+    * CAL controller failure for HO 26 during AOV051
+      * one of amplifier stage stopped working. it's been fixed now. it's been repaired now. need to confirm whether it's working fine or not
+    * Autocorrelations have been funky for couple of H0 26 experiments ( AOV051 & R1966)
+      * might have been something to do with proc files. it should be fixed now. please keep an eye if any problem occurs in future
+**Handover Issues**
+  * Hb 12:
+    * AOV051: Experiment started with recording in only one stream. Check and make sure that it's record each scan in three stream(sxy,xx,xy) at the start of experiment.
+       * Jamie and Guifre working on smoothing the whole procedure of running different scripts for mixed mode exp. but till then keep an eye on issues and upadte the handover/setup notes for mixed modes whenever you find something useful.
+  * H0 26
+    * Mk5 wasn't communicating with fs. restarting drive dv seems to fixed it but still no recording. Maybe module issue? Power cycle of dbbc done the job at last.