This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

--- operations:documentation.dbbcsetupivs [2014/03/24 23:51]
Vasaant Krishnan
+++ operations:documentation.dbbcsetupivs [2016/05/16 12:48] (current)
Bryn Emptage
@@ Line 33: / Line 33: @@
 You now need to set up the IF system. The commands to do this depend on the IVS observation and the station.
-For R1, R4, CRF, AUSTRAL and RDV experiments on they should be:
+For R1, R4, CRF, CRDS, AUSTRAL and RDV experiments on they should be:
 <code>
 dbbcifa=1,agc,1
@@ Line 43: / Line 43: @@
-For APSG, CRDS, OHIG and T2 experiments, for all stations they should be:
+For APSG, OHIG and T2 experiments, for all stations they should be:
 <code>
 dbbcifa=1,agc,1
@@ Line 52: / Line 52: @@
 </code>
-The target values for the total power readings is 56000. this can be checked by the command: ifa, ifb, ifc or ifd]. If the levels are too high or low, then adjust the attenuation on the IF box. Note that the levels on IF C (dbbcifc) are a bit low. Don't worry about it.
+Recommended DBBC power levels can be found [[hardware:dbbc.targetifpower|here]]. Current target values for the total power readings is 56000. this can be checked by the command: ifa, ifb, ifc or ifd. If the levels are too high or low, then adjust the attenuation on the IF box. Note that the levels on IF C (e-remote control command: ifc) are a bit low. Don't worry about it.