This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
operations:documentation.ivs [2012/05/25 01:07] Jamie McCallum [Setting Up] |
operations:documentation.ivs [2013/10/03 05:22] (current) Imogen Jones [Setting Up] |
||
|---|---|---|---|
| Line 31: | Line 31: | ||
| mk5=protect=off\\ | mk5=protect=off\\ | ||
| mk5=reset=erase | mk5=reset=erase | ||
| + | |||
| + | Make sure there are no other experiments on the module or you will erase those too with this command!! | ||
| + | |||
| **Running the Schedule** | **Running the Schedule** | ||
| Line 48: | Line 51: | ||
| * disk_pos should report three values - the current number of btyes recorded, bytes at start of previous scan and bytes at start of current scan. If not currently recording, the first and third values should agree.\\ | * disk_pos should report three values - the current number of btyes recorded, bytes at start of previous scan and bytes at start of current scan. If not currently recording, the first and third values should agree.\\ | ||
| * decoder time - Check time offset in the formatter with "mk5=dot?" and check that it reports a small offset as the final value, than syncerr_eq_0 and that FHG_on or FHG_off depending on whether it is currently recording or not.\\ | * decoder time - Check time offset in the formatter with "mk5=dot?" and check that it reports a small offset as the final value, than syncerr_eq_0 and that FHG_on or FHG_off depending on whether it is currently recording or not.\\ | ||
| - | * Check mode with "mk5=mode?". The result should be "/mk5/!mode? 0 : ext : 0x55555555 : 2 : 2 ;" | + | * Check mode with "mk5=mode?". The result should be "/mk5/!mode? 0 : ext : 0x55555555 : 2 : 2 "; (where the last number is either 1 or 2, the number of disk modules loaded |