User Tools
operations:rf_if_check_9.10.5
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
operations:rf_if_check_9.10.5 [2015/06/04 07:01] Lucia McCallum |
operations:rf_if_check_9.10.5 [2016/10/17 09:18] (current) Ross Turner |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| IF attenuation to nominal: | IF attenuation to nominal: | ||
| <code>ifnom</code> | <code>ifnom</code> | ||
| - | <note important>Occasionally these commands may report a communications error. If this happens, try re-issuing the command.</note> | + | <note important>Occasionally these commands may report a communications error. If this happens, try re-issuing the command. |
| + | If the issue persists, it may be necessary to restart Monica's Rxmon and IFBox on pcfs.</note> | ||
| + | |||
| + | * [[restart_monica_rxmon_ifbox|Restart Rxmon and IFBox]] | ||
| To set these values manually, use the nc (netcat) command and appropriate ASCII code given above. For example, to set the attenuators at Yarragadee, log in as //oper// to //pcfsyg// and type: | To set these values manually, use the nc (netcat) command and appropriate ASCII code given above. For example, to set the attenuators at Yarragadee, log in as //oper// to //pcfsyg// and type: | ||
/home/www/auscope/opswiki/data/attic/operations/rf_if_check_9.10.5.1433401308.txt.gz · Last modified: 2015/06/04 07:01 by Lucia McCallum
Page Tools
