====== Notes on Test Setup in AuScope Control Room ======

===== PC Software =====

Software installed on windows PC (ops1) in control room
  * From the Resource DVD:
    * PC200W
    * RTMC web server (started installing after PC200W automatically!)
    * SCWin (aka Short Cut)
    * Device Configuration Utility
    * SMS (Storage module software)
    * RTMC Pro 4.0 Trial
    * RTMC Web Server 3.2 Trial (not sure if this was already done or not)
    * RTDAQ 1.0 Trial (selected trial when asked for serial number)
    * PCTDR 2.07
  * From the LoggerNet CD
    * Installed the software (key printed on CD)

  * Ran LoggerNet and started through setup wizard
    * Selected CR1000, named it Array 1
    * Selected IP Port as Communication Setup
    * Now need to give it an IP address...
      * Will configure over serial connection
      * USB to serial connector required driver from manufacturer:
        * Manual at at http://sabrent.com/product-manuals/USB-TO-SERIAL-CABLES_Manual.pdf
        * Want driver for SBT-USC6K from http://www.sabrent.com/downloads.php
        * Followed installation instructions
        * Came up on COM3, 9600 baud, 8 bit, parity none, stop bits 1, flow control none.
      * Connected power to logger via DC power-pack. No luck. Direct connection to battery works
      * MAC address for Array 1 00d02c04b057, Array 2 00d02c04b051 and temporary IP addresses are 131.217.62.92 and .93 respectively and called AUScope-Array1.phys... and AUScope-Array2.phys...
      * In Device Config Utility, 
        * Connection over serial with ethernet plugged in, shown DHCP working and TCP port set to 6785
        * In Datalogger tab, Station name is Array1, PakBus Address 1, security code 0
        * edited .cipasswd file (New Services Tab) to give usual observer password for admin, FTP password for anonymous is the same
        * In logger Control, hit Set clock (synchs with PC clock, so that needs to be on an NTP server)
        * In data monitor, can see logged data (after plugging in sensors), other stats like batther level etc.
        * Finished, so disconnect.
      * Now in EZSetup Wizzard
        *  IP address set to 131.217.62.92:6785, pakbus 1, security code 0
        * Comm test worked!
      * Configured Array2 as above, just different name and I address, PakBus Address 1 (tried 2 but failed the comms test).