=======Meeting 9th November=======

Chair: Ross

Present: Jamie, Bryn, Tiege, Patrick, Jesse, Liz, Arwin

Apologies: Jonny, Lucas, Lucia

Absent: 

General Issues:
   - Calendar didn't include Hobart even though it was on the master schedule. The 26m was a late addition to the AUA schedule. Should be avoided in future.
      - Let Jamie know if you don't have access rights to the calendar.
      - nobs looks at master schedule. Warren's script already checks master schedule.
      - CHECK THE MASTER SCHEDULE! and the start time.
  - Jesse sent around an email about script. Works for ho, hb, ke and yg, and opens most of the windows needed.
      - didn't put delay plots in the right position; this is because they were already open.
      - run windex before windows if there is stuff open.

Handover Issues:
  - Ho: iread power levels are a bit low 28000 and 38000 of 48000 | changing attentuation did nothing to help (OHG109)
     - mot an issue: got a different frequency range for O'Higgins (uses Mark 4 rack), slightly smaller range, different power and temperatures. Not paying attention to read in this experiment. Needs more tests.
     - Tsys temperatures below 200 now seem okay, probably degradation of the system. Measured wrong due to absolute calibration error but maybe 10-20% due to the degradation.
  - Ho: problems with cryo temp (OHG109 and AUA031)
     - Just summer maybe. Also receiver pressure a bit dodgy, at 4 microns. Build of gases, got over 5 microns last night but was pumped down. Summer season so cryo problems likely to be more of an issue. Keep an eye out.
  - Ke: Ran fivept several times, the offsets are looking a bit dodgy (AUA031)
     - Problem after bad storms in Katherine. Bryn could get below 0.04 offset even after several attempts. Jamie to work on this.
     - Similarly, fringe testing is quite rubbish these days.
  - Yg: alarms going off for illegal state error and unable to read systemclock1. antenna=open antenna=operate fixed the issue (R1816)
     - Bryn breaks stuff. This issue has come up for both Tiege and Liz too. HMI clock get confused about the time; need to reset if the simple fix fails.