0. Rich & Brett:

  - Ho receiver on-axis comment is confirmation of correct positioning

>  1. Issues from Ww

  - Real time etransfer to Bonn partially successful, Harro explained that there was a port conflict, try again next week
  - New power switch on gpib, not RS-232 yet

>  2. Issues from AuScope

  - Still working on Broadband receiver on 12m

> Review of reported station issues:
> 
>  3. Ww has new internet power switch to cylce GPIB when it fails
>     will replace GPIB controller with RS-232 connection

  - See above

>  4. Yg r4696
>     VNC connection lost for several hours, no monitor
>         (what about eRemoteControl?)

  - Report was VPN down (not VNC, but that was too), everything continued as normal at the site
  - Ww also has a VPN with VNC over it

>  5. Yg r1699
>     Monica restarted twice due to ifpic problems, not fixed?

  - operator talked to Jim about it, should have just restarted ifpic server
  - ifpic server needs to be updated

>  6. Yg says "wth" not found, fixed? (& in all sy= commands?)

  - Jamie fixed, there was an error with ampersand put in by mistake
  - all sy commands updated with ampersand

>  7. Ke r1699
>     S1-S4 high Tsys most of the time (120-170k)

  - example of operator report of high Tsys
  - RFI issue? yes, persistent and reported unevenly, but not too bad
  - DBBC problem? Tsys is high, but cal diode val might also be high
  - Ww core board replacement dropped SEFDs from 8000 to 4000 
    - AuScope 3500 SEFDs so core boards probably okay there
 
>  8. Ho
>     RFI, overflows in S5, S6 most of the time

  - Radiolinks for wireless systems, also gets Hb
    - Consider new frequencies

> Issues left over from last time:
> 
>  9. 0.7 nanosecond clock jumps causing significant data loss during
>     analysis

  - Yg and Hb (and Ho): timing system or Maser PPS or PPS delay in DBBC
  - Rick ask analysts for times of jumps (we also percentage of loss)
  - NR maser still at Hb/Ho, but just used for frequency comparison

> 10. wind-stow progress, next test

  - next week firm up time for Wed/Thurs
  - apparent 'man in the middle attack' for pcfshb due to back-up

> 11. Brian agreed there is no need to move pcal to 26m

  - Okay

> 12. NTP configuration, need more servers, especially remote and
>     non-TAC/CNS

  - Ed contacted Hambly, plans to fix CNS clock firmware to include leap second approaching flag
  - NTP configurations need more servers, especially remote (6 or more) and not CNS clocks, but more local of any type is better too
    - Jim said okay to increasing server

> 13. "popen uptime" was added to all three AuScope 12m systems

  - Installed, waiting for a case where a machine is slowed down to be useful

> 14. Ed and Stuart to review status registers

  - Stuart will send documentation on Ww status registers for Ed to compare with other 12m antennas

> 15. Thanks for IPS/KVM/auto-login information

  - Thanks.
  - Can require a large load on UPS supplying IPS, but has two inputs
  - Brett/Stuart: Wireless switch can switch device from phone
    - "Pebble" unit, "Wemo" by Belkin 
    - Telnet very handy, web interface can bog down
    - need more webcams for looking at equipment

> 16. Ho antcn reliability issues?

  - working on updating the antenna controller

> 17. Any luck getting spare VC parts? switch to DBBC at Ho?

  - Need some oscillator parts from Mike
    - now know what parts to ask for
  - DBBC has two CoMo/four AD2s so not quite compatible with IFs
    - will DBBC 105F support more than eight BBCs? Gino will know