pre-exp: Manually drudged snp, and proc files from the skd located in /home/oper/ on each machine – hopefully these are all fine
Hobart
Module: GSFC+022 (8TB), start pos 0.32 GB
1800UT - Experiment started ok (JS)
0243UT - wind stow. missed scans 343-0239 through 343-0258 inclusive (released shortly in between). (Lucia)
0425UT - wind stow. Started in middle of scan 343-0415, through to 343-0430. (Lucia)
0553UT - wind stow. missed scans 343-0554 through 345-0648
Previous wind stow was not recovered from. Had to reset drives etc however hb then immediately wind stowed again. Turns out it was really stuck and the technique on the current issues page didn't work after multiple times. However, I did a 'reboot system' on a UoT Antenna control (or reboot central, maybe both) and after I did the antenna=off, terminate, etc thing it suddenly worked. I'm guessing it needed a full system reset to clear it's queue (maybe?). (Lucas). First valid scan after prolonged wind stow event (see above) 345-0648
Missed scans due to an auto-stow event. No alarm at beginning of auto-stow but alarm when 'previous source in schedule not reached'. 4mins later auto-stow was released and restart after auto-stow was successful. Missed scans were 343-1231 and 343-1234 (Lucas).
Katherine
Module: HOB+0131 (32TB), start pos 0 GB
Yarragadee
Module: IAAE-018 (8TB), start pos 1606 GB
Module: JIVE-057 (2TB), start pos 0 GB
1740UT Yg short on modules, will have to reuse IAAE-018 and spill-over onto the 2TB in bank A (JS)
1800UT - Experiment started ok (JS)
1952UT recorded data lagging expected by 7.24
GB (JS)
2053UT recorded data lagging expected by 9.93
GB (JS)
0503UT recorded data lagging expected by 28
GB (Lucia)