User Tools

Site Tools


This wiki is not maintained! Do not use this when setting up AuScope experiments!

Notes on Test Setup in AuScope Control Room

PC Software

Software installed on windows PC (ops1) in control room

  • From the Resource DVD:
    • PC200W
    • RTMC web server (started installing after PC200W automatically!)
    • SCWin (aka Short Cut)
    • Device Configuration Utility
    • SMS (Storage module software)
    • RTMC Pro 4.0 Trial
    • RTMC Web Server 3.2 Trial (not sure if this was already done or not)
    • RTDAQ 1.0 Trial (selected trial when asked for serial number)
    • PCTDR 2.07
  • From the LoggerNet CD
    • Installed the software (key printed on CD)
  • Ran LoggerNet and started through setup wizard
    • Selected CR1000, named it Array 1
    • Selected IP Port as Communication Setup
    • Now need to give it an IP address…
      • Will configure over serial connection
      • USB to serial connector required driver from manufacturer:
      • Connected power to logger via DC power-pack. No luck. Direct connection to battery works
      • MAC address for Array 1 00d02c04b057, Array 2 00d02c04b051 and temporary IP addresses are and .93 respectively and called AUScope-Array1.phys… and AUScope-Array2.phys…
      • In Device Config Utility,
        • Connection over serial with ethernet plugged in, shown DHCP working and TCP port set to 6785
        • In Datalogger tab, Station name is Array1, PakBus Address 1, security code 0
        • edited .cipasswd file (New Services Tab) to give usual observer password for admin, FTP password for anonymous is the same
        • In logger Control, hit Set clock (synchs with PC clock, so that needs to be on an NTP server)
        • In data monitor, can see logged data (after plugging in sensors), other stats like batther level etc.
        • Finished, so disconnect.
      • Now in EZSetup Wizzard
        • IP address set to, pakbus 1, security code 0
        • Comm test worked!
      • Configured Array2 as above, just different name and I address, PakBus Address 1 (tried 2 but failed the comms test).
/home/www/auscope/opswiki/data/pages/deformation/testsetup1.txt · Last modified: 2012/11/29 05:19 by Jim Lovell