This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
handover:aua047 [2018/12/05 10:58] Tiege McCarthy |
handover:aua047 [2018/12/05 15:42] Tiege McCarthy |
||
---|---|---|---|
Line 9: | Line 9: | ||
* Fixed problem by resetting the drive pc (vdesk would not load sys26m which was a large diagnostic) with command: rem_reboot -r rakbus sys26m. For good measure, also opened vdesk with sys26m and abort, abort-ed. Then reset field system and voila, it worked. note - found this fix on the ra-wiki (not auscope wiki). | * Fixed problem by resetting the drive pc (vdesk would not load sys26m which was a large diagnostic) with command: rem_reboot -r rakbus sys26m. For good measure, also opened vdesk with sys26m and abort, abort-ed. Then reset field system and voila, it worked. note - found this fix on the ra-wiki (not auscope wiki). | ||
* First scan is 3338-1857, all previous scans missed. | * First scan is 3338-1857, all previous scans missed. | ||
+ | * sx receiver parameter pres out of range showed up multiple times from 1414UT. However the values on the live page seem to be fine (Prad). | ||
**Katherine 12m** | **Katherine 12m** | ||
Line 16: | Line 17: | ||
* Experiment started one scan late, missed scan 338-1730 (Lucas). | * Experiment started one scan late, missed scan 338-1730 (Lucas). | ||
* 10:30 UT, started getting alarms about: | * 10:30 UT, started getting alarms about: | ||
- | 2018.339.10:52:46.01?ERROR st -5 Error return from antenna, see Mbus error. | + | |
- | 2018.339.10:53:01.01?ERROR st -998 reading SystemClock1 | + | 2018.339.10:52:46.01?ERROR st -5 Error return from antenna, see Mbus error. |
- | 2018.339.10:53:01.01?ERROR st -999 TCP/IP connection was closed by remote peer | + | 2018.339.10:53:01.01?ERROR st -998 reading SystemClock1 |
- | | + | 2018.339.10:53:01.01?ERROR st -999 TCP/IP connection was closed by remote peer |
- | * and antenna=open, antenna=operate did not solve the issue. I first reset the drives on timeke, and when that also failed to work after open/operate, rebooted the system in timeke. Then after antenna=open, antenna=operate this worked. Normally this is not necessary but this time it was - Lucas. | + | |
+ | and antenna=open, antenna=operate did not solve the issue. I first reset the drives on timeke, and when that also failed to work after open/operate, rebooted the system in timeke. Then after antenna=open, antenna=operate this worked. Normally this is not necessary but this time it was - Lucas. | ||
**Yarragadee 12m** | **Yarragadee 12m** |