User Tools

Site Tools


handover:aua055

This wiki is not maintained! Do not use this when setting up AuScope experiments!

AUA055

Hobart 26m

Disk VSN: HOB+0111| Data volume at beginning: 0.897 GB

  • 1730UT - Experiment started OK (Tiege)
  • 1808UT - DIMino crashed on mk5hb halfway through scan no0008, needed to restart DIMino. Back OK for no0009 (Tiege)
  • 1810UT - Wind stows are starting to come in now (Tiege)
  • 2100UT - Frequent wind-stowing throughout the morning. (Tiege)
  • 0144UT(233) - Wind stowed (warren)
  • 0223UT - Wind stow released, on source and recording (w)
  • 0345UT - wind stowed(w)
  • 0356UT - on source for scan aua055_ho_no0104 (w)
  • 0435UT - wind stowed mid scan aua055_ho_no0110 (w)
  • 0548UT - onsource and recording for aua055_ho_no0123 (w)
  • 1522UT - wind stow activated (Jay).
  • 1711UT - onsource and tracking from mid scan for scan no0236 (Jay).

Yarragadee 12m

Disk VSN: HOB+0113 | Data volume at beginning: 4.231 GB

  • 1730UT - Problems with Mark5 recorder are preventing experiment from starting. Mark5 crashed during disk transfer. attempting to fix now. (Tiege)
  • 1748UT - Autocorrs were completely trash and iread was showing 0 for two IFs. All issues were fixed by multiple power cycles of the mk5, along with restarting dbbc software and resyncing. ntpq -np reports an offset to the GPS of -17ms which is not ideal, however, before power cycling the mk5 it was at around -150ms. I am going to leave it as is because it seems like the data is OK, but will mention to Warren at change over. First good scan no0007 (Tiege)
  • 23:05 UT - ntp gps delay 14 and offset 85 ms , DOT(data observe time) syncerr = 0 (Warren)
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/pages/handover/aua055.txt · Last modified: 2019/08/21 17:13 by Pradyumna Kiran Kummamuru