User Tools

Site Tools


handover:aust41_42

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
handover:aust41_42 [2014/08/16 02:29]
Warren Hankey
handover:aust41_42 [2014/08/17 05:32] (current)
Ross Turner
Line 9: Line 9:
  
  ​ATTENTION! ​ Looks like module in bank B USN+0224 has bad soft VSN (name too long warning) will need to sort out when there is a substantial gap in scans.  ​ATTENTION! ​ Looks like module in bank B USN+0224 has bad soft VSN (name too long warning) will need to sort out when there is a substantial gap in scans.
 +
 +Aust42 commenced on bank B module USN+0224, as above.
  
 Hb: Hb:
Line 14: Line 16:
 Recording to HOB+0041 starting at zero GB. Recording to HOB+0041 starting at zero GB.
  
-Hb has only HOB+0041/6000 plus half of USN-0114/​4000 that already contains R4648hb, summing up to 8TB. Module change should be performed ​by one of the observers some time on Saturday. + ​Module changed in A to HOB+0023 6 TB ready for aust42 ​by Warren ​on Saturday. 
-cheers, Liza+ 
 +Hb automatically changed to bank A for start of scan 229-0530.
  
 Yg: Yg:
Line 21: Line 24:
 Antenna stuck. Not in windstow, elevation brakes wont release. Dave local at yg went out to reset power in pedestal. Still no joy. Antenna stuck. Not in windstow, elevation brakes wont release. Dave local at yg went out to reset power in pedestal. Still no joy.
  
- Move to Current Issues! Elevation brakes will not release. Need to switch power off in pedestal, open cabinet and switch to maintenance mode. Switch power back on, but this time to hand box control. Should be able to drive by hand. Switch power back over to remote mode. HMI interface should now drive telescope might need to "​Reboot Central"​ in HMI. fs, antenna=open,​ antenna=operate,​ resume schedule. Good luck with all of that....+ Move to Current Issues! Elevation brakes will not release. fs, halt schedule. Need to switch power off in pedestal, open cabinet and switch to maintenance mode. Switch power back on, but this time to hand box control. Should be able to drive by hand. Switch power back over to remote mode. HMI interface should now drive telescope might need to "​Reboot Central"​ in HMI. fs, antenna=open,​ antenna=operate,​ resume schedule. Good luck with all of that....
  
 Recorded data is -404 GB short of scheduled, due to late start. Recorded data is -404 GB short of scheduled, due to late start.
/home/www/auscope/opswiki/data/attic/handover/aust41_42.1408156195.txt.gz · Last modified: 2014/08/16 02:29 by Warren Hankey