User Tools

Site Tools


This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!



has no modules in mk5ke to continue with those experiments. The module UAO-0018, that is in now, contains R4648ke and to be shipped to Washington. Perhaps there is a module in mk5-2ke and one can to switch to it, but I do not know, better call Martin.

Module USN+0224 8000 GB was loaded in Bank B but key not turned on! Martin attempting to get there, but probably expect late start….

Recording finally started to USN+0225 at 00:39 after modules sorted. Looks like module in B has bad VSN (name too long) will need to sort out when there is a substantial gap in scans.


Hb has only HOB+0041/6000 plus half of USN-0114/4000 that already contains R4648hb, summing up to 8TB. Module change should be performed by one of the observers some time on Saturday.

cheers, Liza


Antenna suck. Not in windstow. Dave at yg went out to reset power in pedestal. Still no joy. Current Issue! Elevation brakes will not release. Need to switch power off in pedestal, open cabinet and switch to maintenance mode. Switch power back on, but to hand box control. See if you can drive it. Switch power back to remote mode. See if HMI interface can now drive telescope. Good luck with all of that….

You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/handover/aust41_42.1408151919.txt.gz · Last modified: 2014/08/16 01:18 by Warren Hankey