User Tools

Site Tools


handover:hob006

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
handover:hob006 [2016/10/22 01:06]
Jim Lovell
handover:hob006 [2016/10/22 07:16] (current)
Jim Lovell
Line 17: Line 17:
     * Hydraulics fault was caused by circuit break as the motor wasn't covered and water got in. Collaborative effort of Eric and Brett solved the problem. (Lucas).     * Hydraulics fault was caused by circuit break as the motor wasn't covered and water got in. Collaborative effort of Eric and Brett solved the problem. (Lucas).
   * GPIB device continues to time-out, however delay difference is still stable and < 0.3. Counters are being monitored on rack camera to make sure that severe drifts don't occur whilst Eric investigates. (Lucas).   * GPIB device continues to time-out, however delay difference is still stable and < 0.3. Counters are being monitored on rack camera to make sure that severe drifts don't occur whilst Eric investigates. (Lucas).
-  * 23:50 UT - schedule resumed. First scan  295-2351. GPIB still a problem though, reporting massive delay differences every scan. Clkoff ​value looks reasonable. (Ellen) +  * 23:50 UT - schedule resumed, lost about 500 GB. First scan  295-2351. GPIB still a problem though, reporting massive delay differences every scan. Clkoff ​values ​looks reasonable. (Ellen) 
-  * 01:04 UT - Eric has reset the GPID device and it is still a problem. (Ellen)+  * 01:04 UT - Eric has reset the GPIB device and it is still a problem. (Ellen
 +  * 01:11 UT - Tsys values all overflowing again, restarted CAL again and everything is fine. The CAL has dropped out like this halfway through an experiment before. (Ellen) 
 +  * 01:22 UT - Jamie has turned the GPIB off so that we are no longer measuring a delay difference because it's wrong anyway. Keeping an eye on dbbc=pps_delay instead. (Ellen) 
 +  * 02:17 UT - CAL needed resetting again. And several other times. (Ellen) 
 +  * 07:15 UT - CAL reset again. (Ross)
  
  
/home/www/auscope/opswiki/data/attic/handover/hob006.1477098386.txt.gz · Last modified: 2016/10/22 01:06 by Jim Lovell