This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
handover:r1746 [2016/06/27 16:53] Ross Turner |
handover:r1746 [2016/06/28 12:44] Ross Turner |
||
---|---|---|---|
Line 2: | Line 2: | ||
- | Katherine 12m: | + | **Katherine 12m:** |
- | Disk VSN: | + | Disk VSN: HOB+0105 |
- | Data volume at beginning: | + | Data volume at beginning: 10141 gb |
- | Yarragadee 12m: | + | * 15:52 UT Suddenly had many instances of the following error "WARNING: error st -27 computer acu time difference exceeded 0.25 seconds, see value above.". It eventually stopped, all seems okay. Wiki says this error arises when etransfers are going on, can be safely ignored. (Arwin) |
+ | * 17:00 UT Experiment started OK (Arwin) | ||
+ | * Setup code was "setup8f" not "setupsx" (Arwin) | ||
+ | * Temp sensor on system monitor not working (Arwin) | ||
+ | * 12:39 UT disk_pos is approx. 15 gb behind where it should be. At the previous check (10:36 UT) disk_pos lagged by 4 gb, keeping an eye on it.(Arwin) | ||
- | Disk VSN: | + | |
+ | **Yarragadee 12m:** | ||
+ | |||
+ | |||
+ | Disk VSN: HOB+0102 | ||
+ | |||
+ | Data volume at beginning: 10141 gb | ||
+ | |||
+ | * 17:00 UT Experiment started OK (Arwin) | ||
+ | * 17:05 UT Mark5 lost connection and fmset would not display anything. Halted the schedule. Tried restarting the fs and Dimino but to no avail. Jamie rebooted mark5 and Dimino and made sure ntpq -nq servers were sensible. Fmset came back at this point. Restarted the schedule. Scans missed 179-1705 - 179-1829. (Arwin) | ||
+ | * 18:32 UT started recording again. (Arwin) | ||
+ | * Humidity showing up as zero despite some light rain in the area, sensor not working? (Arwin) | ||
Line 17: | Line 32: | ||
~~DISCUSSION~~ | ~~DISCUSSION~~ | ||
- |