User Tools

Site Tools


handover:r1757

This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!


R1757

Hobart 12m

Data Recorded to MED-0038, disk_pos 0 GBs

  • 17:00 UT - Experiment started OK. (Tiege)

Katherine

Data Recorded to USN-0069 (mk5ke) and USN-0017 (mk5-2ke), disk_pos 0 GBs

  • 17:00 UT - Experiment started OK (Tiege)
  • ~17:30 UT - Noticed that I was consistently getting the warning “WARNING: error sc -13 setcl: formatter to fs time difference 0.5 seconds or greater”. Tried fixing this in all the ways listed on the wiki. mk5=dot? returned large numbers for the last value. Monitoring fmset, the times seemed to be synced when data was not being recorded, however, when recording started mk5 became heavily out of sync. After trying multiple times to fmset, and to restart dimino on mk5ke, I attempted to power cycle the mk5ke using the ip switch. Unfortunately after the power cycle, I have been unable to ssh into mk5ke. As a work-around (hopefully), I have switched over to mk5-2ke for this experiment by terminating the fs, editing /usr2/control/mk5ad.ctl so that it runs of mk5-2ke and then restarting the experiment. (Tiege)
  • 18:10 UT - Experiment seems to be running fine on mk5-2ke, however, preob clkoff command is failing as it should be calling clkoff-2, I am unsure what file too edit in order to adjust this, will attempt to find it now. (Tiege)
  • 18:30 UT - Unable to find where to adjust clkoff to clkoff-2 in the preob, going to manually check delay difference until Jim starts in the morning and can fix. (Tiege)
  • 18:25 UT - Total missed/dodgy scans list: 256-1700b to 256-1733b inclusive were recorded onto USN-0069 using mk5ke (potentially dodgy), scans 256-1742 through to 256-1802 were missed while switching to mk5-2ke, 256-1808 and 256-1809 WERE RECORDED on the new disk (USN-0017), then 256-1814 through to 256-1827b were missed attempting to correct clkoff issue. (Tiege)
  • 18:30 UT - Experiment should be running as normal from scan 256-1833b onwards. Just note that 256-1808 and 256-1809 were both recorded to this module also. (Tiege)

Yarragadee

Data Recorded to USN-0020, disk_pos 52.1 GBs

  • 17:00 UT - Experiment started OK (Tiege)
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/handover/r1757.1473705657.txt.gz · Last modified: 2016/09/12 18:40 by Jesse Swan