This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
handover:r1819 [2017/11/20 21:34] Arwin Kahlon |
handover:r1819 [2017/11/21 08:28] Tiege McCarthy |
||
---|---|---|---|
Line 15: | Line 15: | ||
* 1635UT - 'E STOP' was not pressed, however, Mick went inside and saw that a yellow light was flashing, so he cycled the power and when everything came back up, the light was not flashing anymore and the telescope was no longer stuck. His comment is as follows "Turned the main switch off for 20 secs then back on. The emergency reset light was blinking and after the turn off/on the light stopped blinking." He mentioned there were some power surges earlier on in the night, and suggested that the power may have gone off and on multiple times during the evening. (Tiege) | * 1635UT - 'E STOP' was not pressed, however, Mick went inside and saw that a yellow light was flashing, so he cycled the power and when everything came back up, the light was not flashing anymore and the telescope was no longer stuck. His comment is as follows "Turned the main switch off for 20 secs then back on. The emergency reset light was blinking and after the turn off/on the light stopped blinking." He mentioned there were some power surges earlier on in the night, and suggested that the power may have gone off and on multiple times during the evening. (Tiege) | ||
* 1700UT - Experiment started OK (Tiege) | * 1700UT - Experiment started OK (Tiege) | ||
+ | * UT 08:27 ALARM: error st -998 reading systemclock1, ALARM: error st -999 tcp/ip connection error. Antenna communication software (antcn) problem. Fixed with commands “antenna=operate” and “antenna=open” (Jonny). Scan 325-0825 missed. | ||
**Yarragadee 12m** | **Yarragadee 12m** |