User Tools
handover:r1819
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
handover:r1819 [2017/11/20 20:54] Arwin Kahlon |
handover:r1819 [2017/11/21 17:16] (current) Arwin Kahlon |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| * 1635UT - 'E STOP' was not pressed, however, Mick went inside and saw that a yellow light was flashing, so he cycled the power and when everything came back up, the light was not flashing anymore and the telescope was no longer stuck. His comment is as follows "Turned the main switch off for 20 secs then back on. The emergency reset light was blinking and after the turn off/on the light stopped blinking." He mentioned there were some power surges earlier on in the night, and suggested that the power may have gone off and on multiple times during the evening. (Tiege) | * 1635UT - 'E STOP' was not pressed, however, Mick went inside and saw that a yellow light was flashing, so he cycled the power and when everything came back up, the light was not flashing anymore and the telescope was no longer stuck. His comment is as follows "Turned the main switch off for 20 secs then back on. The emergency reset light was blinking and after the turn off/on the light stopped blinking." He mentioned there were some power surges earlier on in the night, and suggested that the power may have gone off and on multiple times during the evening. (Tiege) | ||
| * 1700UT - Experiment started OK (Tiege) | * 1700UT - Experiment started OK (Tiege) | ||
| + | * UT 08:27 ALARM: error st -998 reading systemclock1, ALARM: error st -999 tcp/ip connection error. Antenna communication software (antcn) problem. Fixed with commands “antenna=operate” and “antenna=open” (Jonny). Scan 325-0825 missed. | ||
| **Yarragadee 12m** | **Yarragadee 12m** | ||
| Line 24: | Line 24: | ||
| * 1700UT - Experiment started OK (Tiege). | * 1700UT - Experiment started OK (Tiege). | ||
| - | * 2050UT - Yg network has konked out (Tiege) | + | * 2050UT - Yg network has died, attempting to bring it back up, have noticed an inconsistency between the IP address given for the router PC on the wiki, and the one in /etc/hosts. Cant VNC into either IP though, however can ping the one given on the wiki (Tiege) |
| + | * 2115UT - network keeps coming in and out of existence, pings are varying between 200 ms and 16000+ ms, unable to get eremote control connected yet (Tiege) | ||
| + | * 2122UT - Network decided it was time to behave now, eremote control is back working. Network is still slower than usual though. (Tiege) | ||
| + | * 2133UT - Eremote control has lost connection again, however the network is good enough to stream the log, so log monitor is now monitoring the streamed log ("/tmp/yg.log"). ERC is going in and out of being connected as the network fluctuates. (Tiege) | ||
| + | * 1446UT - error m5 -104 mk5cn: time-out, connection closed. antenna=operate and antenna=open fixed it. (Patrick) | ||
| {{tag>}} | {{tag>}} | ||
/home/www/auscope/opswiki/data/attic/handover/r1819.1511211242.txt.gz · Last modified: 2017/11/20 20:54 by Arwin Kahlon
Page Tools
