User Tools

Site Tools


handover:r1819

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
handover:r1819 [2017/11/20 21:34]
Arwin Kahlon
handover:r1819 [2017/11/21 17:16] (current)
Arwin Kahlon
Line 15: Line 15:
    * 1635UT - 'E STOP' was not pressed, however, Mick went inside and saw that a yellow light was flashing, so he cycled the power and when everything came back up, the light was not flashing anymore and the telescope was no longer stuck. His comment is as follows "​Turned the main switch off for 20 secs then back on. The emergency reset light was blinking and after the turn off/on the light stopped blinking."​ He mentioned there were some power surges earlier on in the night, and suggested that the power may have gone off and on multiple times during the evening. (Tiege)    * 1635UT - 'E STOP' was not pressed, however, Mick went inside and saw that a yellow light was flashing, so he cycled the power and when everything came back up, the light was not flashing anymore and the telescope was no longer stuck. His comment is as follows "​Turned the main switch off for 20 secs then back on. The emergency reset light was blinking and after the turn off/on the light stopped blinking."​ He mentioned there were some power surges earlier on in the night, and suggested that the power may have gone off and on multiple times during the evening. (Tiege)
    * 1700UT - Experiment started OK (Tiege)    * 1700UT - Experiment started OK (Tiege)
 +   * UT 08:27 ALARM: error st -998 reading systemclock1,​ ALARM: error st -999 tcp/ip connection error. Antenna communication software (antcn) problem. Fixed with commands “antenna=operate” and “antenna=open” (Jonny). Scan 325-0825 missed.
  
 **Yarragadee 12m** **Yarragadee 12m**
Line 28: Line 28:
   * 2122UT - Network decided it was time to behave now, eremote control is back working. Network is still slower than usual though. (Tiege)   * 2122UT - Network decided it was time to behave now, eremote control is back working. Network is still slower than usual though. (Tiege)
   * 2133UT - Eremote control has lost connection again, however the network is good enough to stream the log, so log monitor is now monitoring the streamed log ("/​tmp/​yg.log"​). ERC is going in and out of being connected as the network fluctuates. (Tiege)   * 2133UT - Eremote control has lost connection again, however the network is good enough to stream the log, so log monitor is now monitoring the streamed log ("/​tmp/​yg.log"​). ERC is going in and out of being connected as the network fluctuates. (Tiege)
 +  * 1446UT - error m5 -104 mk5cn: time-out, connection closed. antenna=operate and antenna=open fixed it. (Patrick)
  
 {{tag>}} {{tag>}}
/home/www/auscope/opswiki/data/attic/handover/r1819.1511213677.txt.gz · Last modified: 2017/11/20 21:34 by Arwin Kahlon