User Tools

Site Tools


handover:r4745

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
handover:r4745 [2016/06/24 02:17]
Arwin Kahlon
handover:r4745 [2016/06/24 18:53] (current)
Ross Turner
Line 1: Line 1:
 ====== R4745 ====== ====== R4745 ======
  
-** Yarragadee 12m ** 
  
-Disk VSN: USN-0005/ 2000.138+** Katherine 12m **
  
-Data volume at beginning0.673 GB+Disk VSNUSN-0155
  
-2016.175.18:​22:​44 Total data recorded =  ​at beginning ​of experiment to A +Data volume ​at beginning: ??
  
-18:40UT E-control froze and couldn'​t ​reboot. Turns out the field system crashed+  * 1830 UT Katherine hasn't started yet. Getting errors about "​2016.175.18:32:​07.65?​ERROR m5  ​-23 mk5cn: error opening, mark 5 probably not running, see above for error" But I don'​t ​know how to make it run? Tried IP switching it (the mk5) off and on again but now the ssh's don't work? Internet failure? (Lucas).
  
-19:16:44 Recording started. First good scan 175-1926b. Disk_pos gives 62.917 GB at this point. (Lucas).+  * 19:10 UT Ellen said that if the ssh oper@mk5ke isn't working then it is most likely the internet being down at KathI'll keep looking through the wiki and reach Brett and/or talk to Jesse about the issue (Lucas).
  
-19:25:06 Eremote control ​has disappeared on the screen (like has a '​bar'​ but no 'under bit')[This was eventually ​fixed by maximising eremote ​control]Continuously monitoring e-remote control monitoring on ops4. (Lucas).+  * 24:04 UT Jamie has fixed the mk5 problem. Finishing set up. Jamie's response " Mick had swapped modules and restarted the mark5 units so that we could use mk5ke for recording again, while mk5-2ke was conditioning another moduleDIMino ​was not running on mk5-2ke, which lead to the mk5cn errors in the FS. I fixed it this morning ​by terminating the FS, editing /usr2/control/mk5ad.ctl to use mk5ke again, and restarting the FS."  
 +  * Intermittent status us slewing errors. (Arwin)
  
 +** Yarragadee 12m **
  
-** Katherine 12m **+Disk VSN: USN-0005/ 2000.138
  
-Disk VSNUSN-0155+Data volume at beginning0.673 GB
  
-Data volume ​at beginning: ??+  * 2016.175.18:​22:​44 Total data recorded =  ​at beginning ​of experiment to A 
  
-  * 1830 UT Katherine hasn't started yet. Getting errors about "​2016.175.18:32:​07.65?​ERROR m5  ​-23 mk5cn: error opening, mark 5 probably not running, see above for error" But I don'​t ​know how to make it run? Tried IP switching it (the mk5) off and on again but now the ssh's don't work? Internet failure? (Lucas).+  * 18:40UT E-control froze and couldn'​t ​reboot. Turns out the field system crashed
  
-  * 19:10 UT Ellen said that if the ssh oper@mk5ke isn't working then it is most likely the internet being down at KathI'll keep looking through the wiki and reach Brett and/or talk to Jesse about the issue (Lucas).+  * 19:16:44 Recording started. First good scan 175-1926b. Disk_pos gives 62.917 GB at this point. (Lucas). 
 + 
 +  * 19:25:06 Eremote control has disappeared on the screen (like has a 'bar' but no 'under bit'). [This was eventually fixed by maximising eremote control]. Continuously monitoring e-remote control monitoring on ops4. (Lucas). 
 +  * 15.15 UT Eremotectrl lost connection, had to restart ​it. There shouldn't be any interruptions ​to the experiment. ​(Arwin) 
 +  * 16.20 UT disk_pos was about 50 gb behind where it should be, pretty consistent over the night. (Arwin)
  
-  * 24:04 UT Jamie has fixed the mk5 problem. Finishing set up. 
  
 {{tag>}} {{tag>}}
Line 32: Line 36:
  
 ~~DISCUSSION~~ ~~DISCUSSION~~
- 
/home/www/auscope/opswiki/data/attic/handover/r4745.1466734622.txt.gz · Last modified: 2016/06/24 02:17 by Arwin Kahlon