User Tools

Site Tools


handover:t2109

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
handover:t2109 [2016/02/17 04:17]
Jim Lovell
handover:t2109 [2016/02/17 11:41] (current)
Jim Lovell
Line 7: Line 7:
   * 2120 UT S-band temps exceptionally high 363--400K for CH 09 -- 12   * 2120 UT S-band temps exceptionally high 363--400K for CH 09 -- 12
   * 2125 UT S-band temps stabilised (~130K)   * 2125 UT S-band temps stabilised (~130K)
 +  * 0542 UT Hobart had the following two errors (AK)
 +       - 05:42:28 WARNING: error an -103 pointing computer tracking errors are too large.
 +       - 05:42:28 WARNING: error qo -301 warning: onsource status is slewing!
 +
  
 **Katherine** **Katherine**
Line 23: Line 27:
       - 03:31:20 WARNING: error an -103 pointing computer tracking errors are too large.       - 03:31:20 WARNING: error an -103 pointing computer tracking errors are too large.
       - 03:31:20 WARNING: error qo -301 warning: onsource status is slewing!       - 03:31:20 WARNING: error qo -301 warning: onsource status is slewing!
 +  * 0524 UT katherine threw the same two errors listed in the comment above (AK)
 +  * mk5=dot? time was slightly high, approx 13 ms. Consulted with Jamie who suggested running "​sy=run setcl offset & " when no data is being recorded. Time was constant around 13 ms even after running the command (AK)
  
 **Yarragadee** **Yarragadee**
Line 29: Line 35:
  
   * 1730 UT Experiment started OK (JS)   * 1730 UT Experiment started OK (JS)
 +  * 11:30UT: Yarragadee want to be called when experiment is finished (18:00) to change over modules (NH)
  
  
  
 ~~DISCUSSION~~ ~~DISCUSSION~~
/home/www/auscope/opswiki/data/attic/handover/t2109.1455682622.txt.gz · Last modified: 2016/02/17 04:17 by Jim Lovell