This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
hardware:mark5.conditioning [2012/09/05 02:42] Moblas people |
hardware:mark5.conditioning [2012/09/05 05:22] (current) Moblas people |
||
---|---|---|---|
Line 2: | Line 2: | ||
Conditioning performs a read/write cycle over the set of disks and identifies and isolates bad sectors. | Conditioning performs a read/write cycle over the set of disks and identifies and isolates bad sectors. | ||
- | To Condition a module: | + | **__To Condition a module:__** |
- | Place the module in Bank A **leaving Bank B empty or unlocked**. | + | Place the module in Bank A **(Leave Bank B empty or unlocked)**. |
On a terminal window on the ops1xx pc enter: <code> | On a terminal window on the ops1xx pc enter: <code> | ||
Line 18: | Line 18: | ||
After many seconds, you should see the program output its first line of info. | After many seconds, you should see the program output its first line of info. | ||
- | When the routine completes , it will say how many seconds it took - **note this to write on the side of the module**. Ensure the time taken is close to normal for that size module - if it is radically different - try conditioning the module again. | + | When the routine completes , it will say how many seconds it took - **note this, to write on the side of the module**. Ensure the time taken is close to normal for that size module - if it is radically different - try conditioning the module again. |
+ | |||
+ | If the script gets in a real tangle, you can usually ctrl-c it and then reset the Mark5 with: <code> SSReset </code> and try again. | ||
+ | |||
+ | It is a good idea to do some [[hardware:mark5.conditioning.postconchecks | post conditioning checks]] | ||
- | Use Dimino and tstdimino to check the vsn and pointer setting after conditioning:<code> | ||
- | dimino -mo -c1 & | ||
- | tstdimino | ||
- | >vsn? | ||
- | >vsn? " need to enter twice to get a nice response" </code> | ||
- | Make sure the vsn is the same as the front label on the module. If it has been corrupted, you can change the vsn by entering: <code> | ||
- | >protect=off | ||
- | >vsn=XXXsxxxx "eg vsn=BKG-0006" </code> | ||
- | To check the pointers are reset to 0: <code> | ||
- | >protect=off | ||
- | >pointers=? " should show 0 : 0 : 0 : 0; " </code> | ||
- | More Handy tstdimino commands:<code> | ||
- | >bank_set=A "select module A" | ||
- | >reset=erase "erase the module without conditioning" </code> | ||
Mark5B manual is here : http://www.haystack.mit.edu/tech/vlbi/mark5/docs/Mark%205B%20users%20manual.pdf | Mark5B manual is here : http://www.haystack.mit.edu/tech/vlbi/mark5/docs/Mark%205B%20users%20manual.pdf |