User Tools

Site Tools


observing:apod

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
observing:apod [2016/07/18 01:56]
Jim Lovell
observing:apod [2016/07/18 23:57]
Jim Lovell
Line 8: Line 8:
   * edited proc file to change mk5 mode to 4 Mbps   * edited proc file to change mk5 mode to 4 Mbps
   * Added checkmk5 procedure   * Added checkmk5 procedure
-  * Tried 1sec updates. Works but can't stop it with a @ command (not enough time?)+  * Tried 1sec updates. Works but can't stop it with a @ command (not enough time?). 2 sec updates are OK though, so going with them.
   * Added some lines to the start of the snap file to put the antenna at the correct az and el for the start of the track.   * Added some lines to the start of the snap file to put the antenna at the correct az and el for the start of the track.
-  * +  * 2016 07 18 at Ke 
 +    * Started in the wrong Azimuth wrap! 
 +    * 2 sec updates blocked all other FS scheduled commands 
 +    * Went to 5 sec for end of track and some data were recorded 
 +    * Look for data between 10:18:30 and 10:20:30 UT
/home/www/auscope/opswiki/data/pages/observing/apod.txt · Last modified: 2016/07/18 23:57 by Jim Lovell