This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
operations:cont14_observatory_check [2014/05/16 04:46] David Horsley [26m antenna Checkout Procedure] |
operations:cont14_observatory_check [2014/05/16 05:04] (current) David Horsley [CONT14 Observatory System Checkout Procedure] |
||
---|---|---|---|
Line 24: | Line 24: | ||
* Follow the [[operations:documentation_cont14_module_swap|CONT14 Module Swapping procedure]] | * Follow the [[operations:documentation_cont14_module_swap|CONT14 Module Swapping procedure]] | ||
* If not running already, [[operations:documentation:start_monica|Start MONICA]] and choose the pre-set ''aust_check'' profile from the GUI for the antenna. e.g. for hobart <code>Navigator -> hb -> aust_check</code> This will plot antenna coordinates, tracking errors and motor currents against time. Note this step is for the 12m antennas only. | * If not running already, [[operations:documentation:start_monica|Start MONICA]] and choose the pre-set ''aust_check'' profile from the GUI for the antenna. e.g. for hobart <code>Navigator -> hb -> aust_check</code> This will plot antenna coordinates, tracking errors and motor currents against time. Note this step is for the 12m antennas only. | ||
+ | |||
+ | Note: need to start MONICA from the command line | ||
+ | <code> | ||
+ | ssh ops-serv2 | ||
+ | ./omc.sh | ||
+ | </code> | ||
Now the checks can begin. Note that the procedure is different for the 12m antennas and Hobart 26m: | Now the checks can begin. Note that the procedure is different for the 12m antennas and Hobart 26m: |