User Tools
operations:documentation.dbbcsetupivs
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
operations:documentation.dbbcsetupivs [2012/11/28 23:30] jayb |
operations:documentation.dbbcsetupivs [2016/05/16 12:48] (current) Bryn Emptage |
||
|---|---|---|---|
| Line 33: | Line 33: | ||
| You now need to set up the IF system. The commands to do this depend on the IVS observation and the station. | You now need to set up the IF system. The commands to do this depend on the IVS observation and the station. | ||
| - | For R1, R4, AUSTRAL and RDV experiments on they should be: | + | For R1, R4, CRF, CRDS, AUSTRAL and RDV experiments on they should be: |
| <code> | <code> | ||
| dbbcifa=1,agc,1 | dbbcifa=1,agc,1 | ||
| Line 43: | Line 43: | ||
| - | For APSG, CRDS, CRF, OHIG and T2 experiments, for all stations they should be: | + | For APSG, OHIG and T2 experiments, for all stations they should be: |
| <code> | <code> | ||
| dbbcifa=1,agc,1 | dbbcifa=1,agc,1 | ||
| Line 52: | Line 52: | ||
| </code> | </code> | ||
| - | The target values for the total power readings is 56000. this can be checked by the command dbbcif[abcd]. If the levels are too high or low, then adjust the attenuation on the IF box. Note that the levels on IF C (dbbcifc) are a bit low. Don't worry about it. | + | Recommended DBBC power levels can be found [[hardware:dbbc.targetifpower|here]]. Current target values for the total power readings is 56000. this can be checked by the command: ifa, ifb, ifc or ifd. If the levels are too high or low, then adjust the attenuation on the IF box. Note that the levels on IF C (e-remote control command: ifc) are a bit low. Don't worry about it. |
/home/www/auscope/opswiki/data/attic/operations/documentation.dbbcsetupivs.1354145451.txt.gz · Last modified: 2012/11/28 23:30 by jayb
Page Tools
