User Tools

Site Tools


operations:documentation.dbbcsetupivs_9.10.5

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
operations:documentation.dbbcsetupivs_9.10.5 [2013/10/03 00:28]
Jim Lovell
operations:documentation.dbbcsetupivs_9.10.5 [2016/07/27 18:19] (current)
Warren Hankey
Line 6: Line 6:
 In ''​C:​\DBBC_CONF\''​ are several configuration files for different experiment types. The default configuration is kept in ''​dbbc_config_file_104.txt''​ and this will be loaded when the server software is started. ​ In ''​C:​\DBBC_CONF\''​ are several configuration files for different experiment types. The default configuration is kept in ''​dbbc_config_file_104.txt''​ and this will be loaded when the server software is started. ​
  
-Check to see if a program called ''​DBBC2 ​ControlDDC ​v104_2.exe''​ is running. If it's not running, start it. There'​s a link to it from the desktop. (Don't have two instances running.) +Check to see if a program called ''​DBBC2 ​Control DDC v104_2.exe''​ is running. If it's not running, start it. There'​s a link to it from the desktop. (Don't have two instances running.) 
-<note important>​Make sure you are running v104_2 of the DBBC Control software ​at Hb and Ke and Yg.</​note>​ +<note important>​Make sure you are running v104_2 of the DBBC Control software.</​note>​ 
-If the DBBC has had a power cycle or if there have been timing problems, or if you just want to be cautious, say "​y"​ when asked if you want to reconfig with the defaults. Configurations will take about 2 minutes. ​+If the DBBC has had a power cycle or if there have been timing problems, or if you just want to be cautious, say "​y"​ when asked if you want to reconfig with the defaults. Configurations will take about 2 minutes. ​The DBBC window will stop at "​Waiting for communication from port 4000" or something to that effect. You will need to enter the command listed below in eRemotecontrol to proceed further. (Arwin)
  
 <note important>​If you did reconfigure the DBBC, synchronise the DBBC to the station pps with the following command from eRemoteControl ​ <note important>​If you did reconfigure the DBBC, synchronise the DBBC to the station pps with the following command from eRemoteControl ​
Line 35: Line 35:
   * ''​dbbc_config_file_104_T2_OHIG.txt''​ for T2 and OHIG   * ''​dbbc_config_file_104_T2_OHIG.txt''​ for T2 and OHIG
   * ''​dbbc_config_file_104_point.txt''​ for pointing observations   * ''​dbbc_config_file_104_point.txt''​ for pointing observations
- 
/home/www/auscope/opswiki/data/attic/operations/documentation.dbbcsetupivs_9.10.5.1380760132.txt.gz · Last modified: 2013/10/03 00:28 by Jim Lovell