User Tools
operations:documentation.dbbcsetupivs_9.10.5
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
operations:documentation.dbbcsetupivs_9.10.5 [2013/10/03 04:21] Jim Lovell |
operations:documentation.dbbcsetupivs_9.10.5 [2016/07/27 18:19] (current) Warren Hankey |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| If you can't connect to the DBBC VNC server, the DBBC may have died. In which case, follow these notes on [[operations:documentation:dbbc_restart|Recovering from a DBBC Failure]] | If you can't connect to the DBBC VNC server, the DBBC may have died. In which case, follow these notes on [[operations:documentation:dbbc_restart|Recovering from a DBBC Failure]] | ||
| - | In ''C:\DBBC_CONF\'' are several configuration files for different experiment types. The default configuration is kept in ''dbbc_config_file_104.txt'' (for Hb and Yg) and ''dbbc_config_file_102.txt'' (for Ke) and this will be loaded when the server software is started. | + | In ''C:\DBBC_CONF\'' are several configuration files for different experiment types. The default configuration is kept in ''dbbc_config_file_104.txt'' and this will be loaded when the server software is started. |
| - | Check to see if a program called ''DBBC2 ControlDDC v104_2.exe'' is running for Hb and Ke, or ''DBBC2 ControlDDC v102.exe'' for Ke. If it's not running, start it. There's a link to it from the desktop. (Don't have two instances running.) | + | Check to see if a program called ''DBBC2 Control DDC v104_2.exe'' is running. If it's not running, start it. There's a link to it from the desktop. (Don't have two instances running.) |
| - | <note important>Make sure you are running v104_2 of the DBBC Control software at Hb and Yg, and v102 at Ke.</note> | + | <note important>Make sure you are running v104_2 of the DBBC Control software.</note> |
| - | If the DBBC has had a power cycle or if there have been timing problems, or if you just want to be cautious, say "y" when asked if you want to reconfig with the defaults. Configurations will take about 2 minutes. | + | If the DBBC has had a power cycle or if there have been timing problems, or if you just want to be cautious, say "y" when asked if you want to reconfig with the defaults. Configurations will take about 2 minutes. The DBBC window will stop at "Waiting for communication from port 4000" or something to that effect. You will need to enter the command listed below in eRemotecontrol to proceed further. (Arwin) |
| <note important>If you did reconfigure the DBBC, synchronise the DBBC to the station pps with the following command from eRemoteControl | <note important>If you did reconfigure the DBBC, synchronise the DBBC to the station pps with the following command from eRemoteControl | ||
/home/www/auscope/opswiki/data/attic/operations/documentation.dbbcsetupivs_9.10.5.1380774073.txt.gz · Last modified: 2013/10/03 04:21 by Jim Lovell
Page Tools
