This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
operations:documentation.dbbcsetupivs_9.10.5 [2014/04/24 04:08] Jim Lovell |
operations:documentation.dbbcsetupivs_9.10.5 [2016/07/27 18:19] (current) Warren Hankey |
||
---|---|---|---|
Line 8: | Line 8: | ||
Check to see if a program called ''DBBC2 Control DDC v104_2.exe'' is running. If it's not running, start it. There's a link to it from the desktop. (Don't have two instances running.) | Check to see if a program called ''DBBC2 Control DDC v104_2.exe'' is running. If it's not running, start it. There's a link to it from the desktop. (Don't have two instances running.) | ||
<note important>Make sure you are running v104_2 of the DBBC Control software.</note> | <note important>Make sure you are running v104_2 of the DBBC Control software.</note> | ||
- | If the DBBC has had a power cycle or if there have been timing problems, or if you just want to be cautious, say "y" when asked if you want to reconfig with the defaults. Configurations will take about 2 minutes. | + | If the DBBC has had a power cycle or if there have been timing problems, or if you just want to be cautious, say "y" when asked if you want to reconfig with the defaults. Configurations will take about 2 minutes. The DBBC window will stop at "Waiting for communication from port 4000" or something to that effect. You will need to enter the command listed below in eRemotecontrol to proceed further. (Arwin) |
<note important>If you did reconfigure the DBBC, synchronise the DBBC to the station pps with the following command from eRemoteControl | <note important>If you did reconfigure the DBBC, synchronise the DBBC to the station pps with the following command from eRemoteControl |