This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
operations:documentation.ivs [2012/05/25 01:05] Jamie McCallum [Setting Up] |
operations:documentation.ivs [2013/10/03 05:22] (current) Imogen Jones [Setting Up] |
||
---|---|---|---|
Line 13: | Line 13: | ||
''/etc/init.d/ntp stop''\\ | ''/etc/init.d/ntp stop''\\ | ||
''ntpdate cnsshb''\\ | ''ntpdate cnsshb''\\ | ||
- | ''/etc/init.d/ntp stop''''\\ | + | ''/etc/init.d/ntp stop'' |
After entering these commands, check the ntp status again. Once the NTP time is ok, you will need to run "fmset" on pcfshb, set the time (with ".") and then sync the formatter ("s", followed by "y"). Exit from fmset as soon as you have finished. | After entering these commands, check the ntp status again. Once the NTP time is ok, you will need to run "fmset" on pcfshb, set the time (with ".") and then sync the formatter ("s", followed by "y"). Exit from fmset as soon as you have finished. | ||
Line 30: | Line 31: | ||
mk5=protect=off\\ | mk5=protect=off\\ | ||
mk5=reset=erase | mk5=reset=erase | ||
+ | |||
+ | Make sure there are no other experiments on the module or you will erase those too with this command!! | ||
+ | |||
**Running the Schedule** | **Running the Schedule** | ||
Line 47: | Line 51: | ||
* disk_pos should report three values - the current number of btyes recorded, bytes at start of previous scan and bytes at start of current scan. If not currently recording, the first and third values should agree.\\ | * disk_pos should report three values - the current number of btyes recorded, bytes at start of previous scan and bytes at start of current scan. If not currently recording, the first and third values should agree.\\ | ||
* decoder time - Check time offset in the formatter with "mk5=dot?" and check that it reports a small offset as the final value, than syncerr_eq_0 and that FHG_on or FHG_off depending on whether it is currently recording or not.\\ | * decoder time - Check time offset in the formatter with "mk5=dot?" and check that it reports a small offset as the final value, than syncerr_eq_0 and that FHG_on or FHG_off depending on whether it is currently recording or not.\\ | ||
- | * Check mode with "mk5=mode?". The result should be "/mk5/!mode? 0 : ext : 0x55555555 : 2 : 2 ;" | + | * Check mode with "mk5=mode?". The result should be "/mk5/!mode? 0 : ext : 0x55555555 : 2 : 2 "; (where the last number is either 1 or 2, the number of disk modules loaded |