User Tools

Site Tools


operations:documentation.ivs.newstart_v3_fs9.10.5

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
operations:documentation.ivs.newstart_v3_fs9.10.5 [2012/11/13 03:08]
Jim Lovell [Starting]
operations:documentation.ivs.newstart_v3_fs9.10.5 [2018/09/25 22:09] (current)
Pradyumna Kiran Kummamuru
Line 66: Line 66:
 >  * [[operations:​documentation.DBBCSetupIVS_9.10.5|DBBC Setup]] >  * [[operations:​documentation.DBBCSetupIVS_9.10.5|DBBC Setup]]
  
-At the start of every scan, the pcfs executes the ''​setupsx'' ​or ''​setup8f''​ procedure (depending on experiment type) which sets the DBBC input channels, filters and BBC frequencies (and configues the Mark5). However, it's a good idea to execute it now so that a recorder test can be made:+At the start of every scan, the pcfs executes the ''​setupsx''​ which sets the DBBC input channels, filters and BBC frequencies (and configues the Mark5). However, it's a good idea to execute it now so that a recorder test can be made:
   * For R1, R4, RD, RDV, T2, ANZ, CRDS, CRF, OHIG:<​code>​setupsx</​code>​   * For R1, R4, RD, RDV, T2, ANZ, CRDS, CRF, OHIG:<​code>​setupsx</​code>​
-  * For AUST, CONT:<​code>​setup8f</​code>​ +  
-''​setupsx'' ​(or ''​setup8f''​) ​calls ''​ifdsx''​ which sets up the DBBC Conditioning module inputs, filters and power levels, then ''​dbbcsx8''​ (or ''​dbbcsx4''​ for a 4 MHz DBBC mode)  which sets the BBC frequencies. Then if you type:+''​setupsx''​ calls ''​ifdsx''​ which sets up the DBBC Conditioning module inputs, filters and power levels, then ''​dbbcsx8''​ (or ''​dbbcsx4''​ for a 4 MHz DBBC mode)  which sets the BBC frequencies. Then if you type:
 <​code>​iread</​code>​ <​code>​iread</​code>​
 You will see what the current Conditioning module settings are. Output format is: You will see what the current Conditioning module settings are. Output format is:
Line 86: Line 86:
 == Mark5 Recorder setup == == Mark5 Recorder setup ==
 Next the Mark5 recorder needs to be prepared for the observations. ​ Next the Mark5 recorder needs to be prepared for the observations. ​
 +
 +If the allocated Mk5 module contains data:
 +
 +Check the remaining space on the module and the compare with the space required for the experiment from the summary file. disk_pos can be used for such purpose. **Do NOT delete any data** unless it is something done as test recording.
  
 If you need to swap disk modules: If you need to swap disk modules:
/home/www/auscope/opswiki/data/attic/operations/documentation.ivs.newstart_v3_fs9.10.5.1352776108.txt.gz · Last modified: 2012/11/13 03:08 by Jim Lovell