User Tools
operations:documentation:lba_dbbc_config
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
operations:documentation:lba_dbbc_config [2013/03/28 05:14] Jim Lovell |
operations:documentation:lba_dbbc_config [2013/03/28 05:18] Jim Lovell [S-band, dual polarisation - 4 channels maximum] |
||
|---|---|---|---|
| Line 148: | Line 148: | ||
| If not re-cabling, then read on... | If not re-cabling, then read on... | ||
| - | This assumes that you will have S_band LCP through CoMo A and S-band | + | In this case the [[hardware:dbbc.routing|IF inputs]] setup dictates that you will have S-band LCP through CoMo A input 4, and S-band RCP through CoMo C, input 2. |
| + | |||
| + | |||
| + | |||
| * Create a new configuration file in @@C:\DBBC_CONF@@ of dbbcke if needed. If the experiment shares a configuration with a previous experiment (same frequencies, polarisations, channel order) then you should be able to use that. Otherwise, read on. | * Create a new configuration file in @@C:\DBBC_CONF@@ of dbbcke if needed. If the experiment shares a configuration with a previous experiment (same frequencies, polarisations, channel order) then you should be able to use that. Otherwise, read on. | ||
/home/www/auscope/opswiki/data/pages/operations/documentation/lba_dbbc_config.txt · Last modified: 2013/03/28 05:35 by Jim Lovell
Page Tools
