This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
operations:monitoring_hb [2014/11/23 19:19] Ellen Manning [clkoff reading is drifting or far from the maser-GPS offset] |
operations:monitoring_hb [2014/11/23 19:43] Ellen Manning [clkoff reading is drifting or far from the maser-GPS offset] |
||
---|---|---|---|
Line 78: | Line 78: | ||
If the delay difference is more than 20 us, or gets so large that the ''clkoff'' or ''maserdelay'' values lose precision, run ''fmset'' to get the delays back to something manageable. //Make sure you are not recording while running fmset! Issuing a ''halt'' command from e-RemoteCtrl followed by ''disk_record=off'' is usually a safe method.// | If the delay difference is more than 20 us, or gets so large that the ''clkoff'' or ''maserdelay'' values lose precision, run ''fmset'' to get the delays back to something manageable. //Make sure you are not recording while running fmset! Issuing a ''halt'' command from e-RemoteCtrl followed by ''disk_record=off'' is usually a safe method.// | ||
+ | |||
+ | The first thing to do is try the command | ||
+ | <code>counter</code> | ||
+ | in e-RemoteCtrl. Check to see if this worked by typing ''clkoff'' and ''maserdelay''. If this doesn't fix it, proceed with the steps below. | ||
If the delay difference is drifting (usually linearly), the DBBC probably needs reconfiguring. This can be done from e-RemoteCtrl as follows (again, best to halt the schedule and make sure you're not recording): | If the delay difference is drifting (usually linearly), the DBBC probably needs reconfiguring. This can be done from e-RemoteCtrl as follows (again, best to halt the schedule and make sure you're not recording): |