User Tools
operations:starting_monitoring
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
operations:starting_monitoring [2012/06/06 09:52] Stas Shabala [If econtrol gets closed during an observation] |
operations:starting_monitoring [2012/07/25 23:34] (current) Jamie McCallum |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| (As a backup, pmSTALM can be used but it checks for fewer error conditions. This is described [[operations:documentation.pmstalm| here]].) | (As a backup, pmSTALM can be used but it checks for fewer error conditions. This is described [[operations:documentation.pmstalm| here]].) | ||
| - | At least 5 min prior to to the scheduled start, start the schedule with e.g. <code>schedule=r4447hb</code> as usual. Note: do NOT specify a start line number. [[operations:startmessage|Then send a start message to IVS]]. | + | For Hobart and Katherine, start the schedule with e.g. <code>schedule=r4447hb</code> if there is longer than 5 minutes until the nominal start of the schedule. For Yarragadee, ALWAYS start the schedule with <code>schedule=r4447yg,#1</code>. This is necessary because the snp file has been edited to deal with the transmission stows which confuses the fs. |
| + | |||
| + | Unless: you try to start late within five minutes of the scheduled start and get errors like; //m5 -900 no scans//;// m5 -900 not while recording or playing//;// m5 -900 can't get device info//. The mk5 is looking for the previous scheduled scan to check, which doesn't exist, and can't start the next scheduled scan recording. In this case start schedule with start line number <code>schedule=r4447hb,#1</code> Otherwise: do NOT specify a start line number. | ||
| + | |||
| + | [[operations:startmessage|Then send a start message to IVS]]. | ||
| During the experiment, the following checks can be made. Please log them using the new Checklist GUI: | During the experiment, the following checks can be made. Please log them using the new Checklist GUI: | ||
/home/www/auscope/opswiki/data/attic/operations/starting_monitoring.1338976342.txt.gz · Last modified: 2012/06/06 09:52 by Stas Shabala
Page Tools
