User Tools
operations:starting_monitoring_9.10.5
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
operations:starting_monitoring_9.10.5 [2016/11/24 21:11] Bryn Emptage [Antenna control and monitoring] |
operations:starting_monitoring_9.10.5 [2017/06/23 03:24] (current) Arwin Kahlon [Antenna stuck] |
||
|---|---|---|---|
| Line 67: | Line 67: | ||
| When the antenna is stuck, launch the VNC to the timepc and go to the antenna control window. Look for red buttons there. Set the schedule to halt in the fs input. You can turn on/ff the antenna manually from operate/standby, switch Drives on/off. If necessary, do the RESETS at the bottom. | When the antenna is stuck, launch the VNC to the timepc and go to the antenna control window. Look for red buttons there. Set the schedule to halt in the fs input. You can turn on/ff the antenna manually from operate/standby, switch Drives on/off. If necessary, do the RESETS at the bottom. | ||
| + | After turning the drives on, it is recommended to wait a little while before putting the antenna in 'operate'. This step is crucial if the previous steps haven't resolved the issue. | ||
| ==== DBBC Crash: ERROR db -21.... ==== | ==== DBBC Crash: ERROR db -21.... ==== | ||
/home/www/auscope/opswiki/data/attic/operations/starting_monitoring_9.10.5.1480021866.txt.gz · Last modified: 2016/11/24 21:11 by Bryn Emptage
Page Tools
