User Tools
deformation:testsetup1
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
deformation:testsetup1 [2012/08/29 03:22] Jim Lovell created |
deformation:testsetup1 [2012/08/29 04:44] Jim Lovell [PC Software] |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| * From the LoggerNet CD | * From the LoggerNet CD | ||
| * Installed the software (key printed on CD) | * Installed the software (key printed on CD) | ||
| - | * | + | |
| + | * Ran LoggerNet and started through setup wizard | ||
| + | * Selected CR1000, named it Array 1 | ||
| + | * Selected IP Port as Communication Setup | ||
| + | * Now need to give it an IP address... | ||
| + | * Will configure over serial connection | ||
| + | * USB to serial connector required driver from manufacturer: | ||
| + | * Manual at at http://sabrent.com/product-manuals/USB-TO-SERIAL-CABLES_Manual.pdf | ||
| + | * Want driver for SBT-USC6K from http://www.sabrent.com/downloads.php | ||
| + | * Followed installation instructions | ||
| + | * Came up on COM3, 9600 baud, 8 bit, parity none, stop bits 1, flow control none. | ||
| + | * Connected power to logger via DC power-pack. Not turned on yet | ||
| + | * | ||
/home/www/auscope/opswiki/data/pages/deformation/testsetup1.txt · Last modified: 2012/11/29 05:19 by Jim Lovell
Page Tools
