This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
handover:r4782 [2017/03/09 18:41] Bryn Emptage |
handover:r4782 [2017/03/10 05:07] Warren Hankey |
||
---|---|---|---|
Line 10: | Line 10: | ||
* 1830 UT Experiment started OK (Bryn) | * 1830 UT Experiment started OK (Bryn) | ||
+ | * New module is loaded in the other bank, should spill over once full. | ||
+ | |||
**Katherine** | **Katherine** | ||
Line 18: | Line 20: | ||
* 1830 UT Experiment started OK (Bryn) | * 1830 UT Experiment started OK (Bryn) | ||
+ | * 0435 UT Telescope had a few issues with the drives here. I got it going once with the antenna=operate and antenna=open. However I dont think it went to source until scan 069-0509. It wasnt ringing an alarm the second time but the log said "antenna stuck". Pretty much all data starting 04:35 to 05:00 is invalid. First scan should be 069-0509. (Arwin) | ||
**Yarragadee** | **Yarragadee** | ||
Line 26: | Line 29: | ||
* 1830 UT Experiment started OK (Bryn) | * 1830 UT Experiment started OK (Bryn) | ||
+ | * 0230 UT yg network was all clogged up. The webacam was hogging all the bandwidth, needed a reset. This was causing problem with the ntpq server getting its time properly which caused a higher than normal offset in the mk5=dot?. The schedule was halted between 2017.069.02:16:17 to 2017.069.03:03:49. Scans missed were 069-0216b to 069-0308b (not inclusive of the last one). If you run comments.py, it should pick this up automatically. (Arwin) | ||
{{tag>}} | {{tag>}} |