This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
operations:documentation.test_recording_fs9.10.5 [2013/11/04 01:36] Imogen Jones |
operations:documentation.test_recording_fs9.10.5 [2013/11/04 01:42] Imogen Jones |
||
---|---|---|---|
Line 12: | Line 12: | ||
The output should appear in the pcfs[hb|ke|yg] VNC session and within a minute on the [[http://auscope.phys.utas.edu.au/spectra.php|Autocorrelation Spectra web page]]. Good data should contain quite flat bandpasses and zero phase. See [[operations:monitoring_autocor|autocorrelation spectra plots]] for an example and what problems to look out for. If there are dropped or strange-looking bands, the [[hardware:dbbc.reprogram|DBBC may need reprogramming]]. | The output should appear in the pcfs[hb|ke|yg] VNC session and within a minute on the [[http://auscope.phys.utas.edu.au/spectra.php|Autocorrelation Spectra web page]]. Good data should contain quite flat bandpasses and zero phase. See [[operations:monitoring_autocor|autocorrelation spectra plots]] for an example and what problems to look out for. If there are dropped or strange-looking bands, the [[hardware:dbbc.reprogram|DBBC may need reprogramming]]. | ||
- | Note: for AUST experiment, to get autocorrelation happening, the different bit rate etc will mean you need to redefine checkmk5 procedure from usual. Edit checkmk5 using pfmed. Look for older AUST proc file for example, define checkmk5 as... | + | Note: The checkmk5 procedure occurs before this, but just in case it hasn't been done: |
+ | For AUST experiment, to get autocorrelation happening, the different bit rate etc will mean you need to redefine checkmk5 procedure from usual. Edit checkmk5 using pfmed. Look for older AUST proc file for example, define checkmk5 as... | ||
<code>define checkmk5 13261230216x | <code>define checkmk5 13261230216x | ||
sy=/home/oper/bin/auto_cor_check_web_2bit_8mhz_hb.sh & | sy=/home/oper/bin/auto_cor_check_web_2bit_8mhz_hb.sh & | ||
Line 18: | Line 19: | ||
mk5=get_stats? | mk5=get_stats? | ||
mk5=status?</code> | mk5=status?</code> | ||
+ | |||
+ | Editing instructions are here: [[operations:documents.ivs.drudg_9.10.5]] | ||
<note warning>DO NOT ERASE TEST SCANS UNLESS ABSOLUTELY NECCESSARY. They don't actually need to be deleted as they do not get picked up in transfers and erasing modules is a risky business!</note> | <note warning>DO NOT ERASE TEST SCANS UNLESS ABSOLUTELY NECCESSARY. They don't actually need to be deleted as they do not get picked up in transfers and erasing modules is a risky business!</note> |