User Tools

Site Tools


operations:operations.vsn_check

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
operations:operations.vsn_check [2012/08/16 02:06]
Jim Lovell
operations:operations.vsn_check [2014/02/12 22:42]
Jim Lovell
Line 15: Line 15:
  
 These cameras have pre-defined way-points (menu in lower right). Select the Mark5 recorder (e.g. for Hobart it's "​mk5hb"​). you may have to pan and zoom a bit to ready the label. Compare the label with the one reported by e-Remote control. If they agree, then fine. If not, see below. These cameras have pre-defined way-points (menu in lower right). Select the Mark5 recorder (e.g. for Hobart it's "​mk5hb"​). you may have to pan and zoom a bit to ready the label. Compare the label with the one reported by e-Remote control. If they agree, then fine. If not, see below.
 +
 +**If it's dark in the Katherine control room** and you can't see the modules, you can [[operations:​documentation:​ke_lights|turn on the lights at Katherine]] but please remember to turn them off again when you're finished to discourage the insects.
  
 If there is a second module loaded, select it as follows: If there is a second module loaded, select it as follows:
/home/www/auscope/opswiki/data/pages/operations/operations.vsn_check.txt · Last modified: 2014/08/25 01:42 by Imogen Jones