User Tools

Site Tools


operations:handover

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Handover notes

Please use this page to write up any notes on anything that needs to be passed on to the next observer or should go into the end of experiment message.

Notes should be placed below the horizontal line as a new blog entry.

Continuing problems should be copied to the Current Issues page.

**Template for Handover notes:**

Be sure to add any specific notes about the experiment if required, for example “Special back end configuration for x reason”. Put as much detail as you can - the more the better.

It is ESSENTIAL to put your name after EVERY entry. Copy and paste the template into the new handover notes

====== Experiment Name ======

**Hobart 12m**

Disk VSN: abc-123 | Data volume at beginning: 2.34 GB

   * 1300UT a comment from me (user)

**Katherine 12m**

Disk VSN: | Data volume at beginning:  GB

   * 

**Yarragadee 12m**

Disk VSN: | Data volume at beginning:  GB

   * 1300UT Experiment started okay (JMc).

Format for entering a comment It is important to stick to this formula - there is a good reason we need this information, so please include it!

Time stamp in UT * Comment * (Your Name)

For Example:

20:00UT: Wind stows, Missed scans 012-3456 to 012-3457 (Jim)

20:50UT: Mark5 lost connection, had to restart Mark5 and reconfigure DBBC, called Jamie on call to fix, missed scans 012-3456 to 012-4567 (Jim)

Again - as much detail as you can. It is important to remember that these notes will be sent to the correlator, so please make sure they make sense to others.


AUST35
  • Hb: disk_pos: 4754.8 GB module: HOB+0039: bank swap necessary. Switched to module HOB+0107 at 05:14:20. No scans lost. New disk_pos: 10946 GB. First scan of aust35 on this module: 201-0515 (source 0727-115)
  • Hb: run late on automatic schedule changeover. Aust34 lasted too long. Missed first 3 scans (onsource SLEWING) trying to catch upcd. First valid scan: 201-0003 (source CTA26).
  • Ke: disk pos: 800.2 GB module: HOB+0088
  • Ke: run late on automatic schedule changeover. Aust34 lasted too long. Missed first 3 scans (onsource SLEWING) trying to catch upcd. First valid scan: 201-0003 (source CTA26).
  • Ke: one bad channel
  • Yg disk_pos: 5314.6 GB, module: HOB+0115
  • Yg: missed first 3 scans, aust34 was running late. first valid scan: First valid scan: 201-0003 (source CTA26).
  • Yg: alarm 2014.201.00:37:24 Delay difference is 11.352 us

2014.201.00:37:24 ALARM: Large difference between formatter and maser delays. Check for stability of new offset. Only one delay difference is that huge. Now its fine again (0.3 us)

2014/08/06 05:57 · 0 Comments
/home/www/auscope/opswiki/data/pages/operations/handover.txt · Last modified: 2018/10/29 16:27 by Jesse Swan