User Tools
Sidebar
This wiki is not maintained! Do not use this when setting up AuScope experiments!
Handover notes
Please use this page to write up any notes on anything that needs to be passed on to the next observer or should go into the end of experiment message.
Notes should be placed below the horizontal line as a new blog entry.
Continuing problems should be copied to the Current Issues page.
**Template for Handover notes:**
Be sure to add any specific notes about the experiment if required, for example “Special back end configuration for x reason”. Put as much detail as you can - the more the better.
====== Experiment Name ====== **Hobart 12m** Disk VSN: abc-123 | Data volume at beginning: 2.34 GB * 1300UT a comment from me (user) **Katherine 12m** Disk VSN: | Data volume at beginning: GB * **Yarragadee 12m** Disk VSN: | Data volume at beginning: GB * 1300UT Experiment started okay (JMc).
Format for entering a comment It is important to stick to this formula - there is a good reason we need this information, so please include it!
Time stamp in UT * Comment * (Your Name)
For Example:
20:00UT: Wind stows, Missed scans 012-3456 to 012-3457 (Jim)
20:50UT: Mark5 lost connection, had to restart Mark5 and reconfigure DBBC, called Jamie on call to fix, missed scans 012-3456 to 012-4567 (Jim)
Again - as much detail as you can. It is important to remember that these notes will be sent to the correlator, so please make sure they make sense to others.
R1815
Katherine
Module: USN-0137, start pos: 0.192 GB
- 1700UT - Experiment started OK (Tiege)
Yarragadee
Module: OSOD-114, start pos: 0.192 GB
- 1700UT - Experiment started OK (Tiege)
R4814
Katherine
Module: NRAO-145, start pos: 0.513 GB
- 1830 - Experiment started ok. (Tiege)
- 08:09:30 - 08:11:30 UT - Report computer ACU time difference error. Did not seem to have any time related problems ie. fmset/delay difference/clkoff…Rectified itself before further investigation (Liz).
Yarragadee
Module: HOB+0047, start pos: 0.256 GB
- 1500 - Antenna drives stuck, needed to “reboot system” on the HMI interface to unstuck (Tiege)
- 1830 - Experiment started ok. (Tiege)
r1814
Hobart 26m:
Disk VSN mk5hb: HOB+0104 Disk VSN mkv: USN+0225
Data volume at beginning: 0 GB on both
- 17:04UT Exp started okay on mk4hb. Mark 4 didnt start recording till 17:17, first scan on mark4 should be 289-1720. Mark4 was unresponsive during setup, had to drive out to mt pleasant to power cycle (Arwin)
- SX receiver pressure out of range, Brett knows about it according to Warren (Ross)
Katherine 12m:
Disk VSN:BKG+0141
Data volume at beginning: 0 GB
- 17:00UT Exp started OK. (Arwin)
Yarragadee 12m:
Disk VSN:USN-0067
Data volume at beginning: 0 GB
- 17:00UT Exp started OK. (Arwin)
R4813
Katherine
Module: OSOD-118, start pos: 0.3GB
- 1830 - Experiment started ok. (Ellen)
Yarragadee
Module: BKG+0120, start pos: 0.4GB
- 1750 UT - System monitor keeps crashing every few minutes since end of last experiment. Just restarting monica seems to have fixed it… (Ellen)
- Seems to be working but refreshes VERY slowly.
- 1830 - Experiment started ok. (Ellen)
ks1710
ho
- wind stowed from 2:42 - 4:59 UT scans(no0556,…. no0593) and from 05:20 - 6:32 UT scans(no0599,…. no0619 ) (Warren)
- Wind stowed from 7:04 - 7:40 UT, scans affected: no0627 through to no0638 . (Patrick)
- 1733UT - Noticed that receiver is hotter in both stages than it's meant to be. I don't think there's much to do about this until Brett comes in in the morning - leaving it until then. (Ellen)
- 2130TU - Reported to Eric, he says they are not that bad but is running the vacuum pump anyway. (Ellen)
apsg41
Katherine
Disk VSN: USN-0097
Data Volume at Beginning: 0.449 GB
- 17:30 UT Experiment started OK (Bryn)
- 06:46 UT Received pointing computer tracking error: (Patrick)
- WARNING: error an -103 pointing computer tracking errors are too large.
- WARNING: error qo -301 warning: onsource status is slewing!
- 06:53 UT, 06:59, 07:48, 08:28 Received above 2 errors again (Patrick)
Slewing errors during scans: 284-1806, 284-1808, 284-1810, 284-1815, 284-1831, 284-1838, 284-1840, 284-1855, 284-1911, 284-1924, 284-1935, 284-2127, 284-2147, 284-2224, 284-2322, 284-2329, 284-2336, 284-2353, 285-0040, 285-0055, 285-0112, 285-0147, 285-0202, 285-0239, 285-0343, 285-0347, 285-0509, 285-0537, 285-0541, 285-0646, 285-0653, 285-0659, 285-0748, 285-0828, 285-1049, 285-1057, 285-1118, 285-1154, 285-1202, 285-1246, 285-1249, 285-1334, 285-1337, 285-1353, 285-1405, 285-1413, 285-1459, 285-1523, 285-1535, 285-1554, 285-1613, 285-1630, 285-1714, 285-1715, 285-1717
Yarragadee
Disk VSN: HOB+1006
Data volume at Beginning: 6461.65 GB
- 17:30 UT Experiment started OK (Bryn)
- 08:27 UT Received pointing computer tracking error: (Patrick)
- WARNING: error an -103 pointing computer tracking errors are too large.
- WARNING: error qo -301 warning: onsource status is slewing!
- 08:28, 09:10, 09:56 Received above 2 errors again (Patrick)
Slewing errors during scans: 284-1808, 284-1810, 284-1815, 284-1829, 284-1833, 284-1922, 284-2020, 284-2034, 284-2106, 284-2126, 284-2129, 284-2131, 284-2135, 284-2217, 284-2251, 284-2255, 284-2326, 284-2334, 284-2352, 285-0040, 285-0050, 285-0052, 285-0142, 285-0144, 285-0147, 285-0239, 285-0317, 285-0340, 285-0343, 285-0345, 285-0347, 285-0455, 285-0458, 285-0509, 285-0519, 285-0827, 285-0828, 285-0910, 285-0959, 285-1049, 285-1209, 285-1249, 285-1253, 285-1401, 285-1534, 285-1535, 285-1630, 285-1657, 285-1714, 285-1715, 285-1717
