This is an old revision of the document!
1. Observational setup 2. Data processing
Required software:
The pipeline to retrieve the Doppler and residual phase can be summarised as:
In therms of software the data processing is summarised in 3 steps:
1- Running the software spectrometer to see the spectrum of the signal recorded (SWspec)
2- Making a first estimate of the pcal measurements (calculatePcalCpp)
3- Running the tracking software (SCtracker)
It takes the raw VLBI data, reads any desired channel and performes a high-resolution integrated-time FFT of the entrie scan. It uses an initial settings file (inifile.ini). I usually store the inifile.ini in the same folder with the results. There are several settings that can be modified. However, the main ones are:
UseFile1Channel = 1
BaseFilename1 = m190522_Hb_VDIF_If000A_%fftpoints%pt_%integrtime%s_ch%channel%
Notes:
# Change then channel value from 1 to 8, one per channel
# Change IF000A to A/B/C/D/E/F to cover all boards
We run the program by executing this line:
swspectrometer inifile.ini /mnt/vbsPcal/m0000_Hb_No0001a.vdif