This wiki is not maintained! Do not use this when setting up AuScope experiments!
This is an old revision of the document!
r1780
Hobart
Disk VSN: HOB+0042
Volume at Beginning: 0GB
Can't connect with eremote control, Dave's backup isn't working either - doing setup with VNC. (Bryn)
Katherine
Disk VSN: CURT+102
Volume at Beginning: 0GB
Yarragadee
Disk VSN: USN-0093
Volume at Beginning: 0GB
Getting lots of errors with the mk5 during setup, probably due to issue with counter (can't run clkoff). Have tried using 'counter' to reset counters, still getting errors as follows:
WARNING: error sc -13 setcl: formatter to fs time difference 0.5 seconds or greater
WARNING: error sc -23 setcl: mark 5b not sync'd, consider using fmset 's' option to fix.
WARNING: error ib -4 gpib device time-out on response c1
WARNING: error m5 -112 mk5cn: eof pre-draining input, mark 5 may have crashed, connection closed
WARNING: error m5 -114 mk5cn: re-open after pre-drain error was okay, proceeding to transaction.
Test recording has times way off, but fmset won't run because of the above errors. Have tried restarting the mk5 - no changes. (Bryn)
mk5 records fine, mk5=dot reports FHG_on. However, running scan_check causes ERROR m5 -900 Can't XLRRead() (Bryn)
Tried physical reboot of system by calling on-site person. Same errors persist. (Bryn)
Apparently some work was done on the wiring of Yg since the last experiment. This might be the source of the issue. If so, there isn't anything I can do remotely. (Bryn)
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/handover/r1780.1487693455.txt.gz · Last modified: 2017/02/21 16:10 by Ross Turner